Investigation of the influence of carbon on the magnetic properties of powder injection molded Nd-Fe-B magnet
Authors:
- 1 May 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21504598,p. 1
Abstract
The fabrication of Nd-Fe-B full-dense magnets by Powder Injection Molding (PIM) has been investigated in previous works [1]-[4]. Such studies were motivated by PIM advantages in attaining complex-shaped magnets without diluting the remanence as in the case of injection molded bonded magnets In this technique, the polymeric binders that act as a temporary vehicle that provide rheology for injection molding, are extracted by thermo-chemical routes prior to the sintering stage. This process is controlled by the applied heating rate and furnace atmosphere, which influence the binder decomposition that, in turn, invariably leaves carbon rich residues.Keywords
This publication has 5 references indexed in Scilit:
- Evaluation of Process Variables in the Alignment Factor of Nd-Fe-B Magnets Made by Metal Injection MoldingIEEE Transactions on Magnetics, 2013
- Study of Carbon Influence on Magnetic Properties of Metal Injection Molding Nd-Fe-B Based MagnetsMaterials Science Forum, 2012
- Some new Nd-rich carbides formed by solid state reaction of and carbonJournal of Physics D: Applied Physics, 1998
- Properties of Anisotropic Nd(Fe, Co)B Type Sintered Magnets Produced by Powder Injection MouldingPowder Metallurgy, 1998
- Microstructure of Nd-rich phase in Nd-Fe-B magnet containing oxygen and carbon impuritiesJournal of Magnetism and Magnetic Materials, 1991