High Temperature Operation of a Solid Polymer Electrolyte Fuel Cell Stack Based on a New Ionomer Membrane
- 3 November 2010
- journal article
- research article
- Published by Wiley in Fuel Cells
- Vol. 10 (6) , 1013-1023
Abstract
Polymer electrolyte fuel cell stacks assembled with Johnson Matthey Fuel Cells and SolviCore MEAs based on the Aquivion™ E79‐03S short‐side chain (SSC), chemically stabilised perfluorosulphonic acid membrane developed by Solvay Solexis were investigated at CNR‐ITAE in the EU Sixth Framework ‘Autobrane' project. Electrochemical experiments in fuel cell short stacks were performed under practical automotive operating conditions at pressures of 1–1.5 bar abs. over a wide temperature range, up to 130 °C, with varying levels of humidity (down to 18% R. H.). The stacks using large area (360 cm2) MEAs showed elevated performance in the temperature range from ambient to 100 °C (cell power density in the range of 600–700 mWcm–2) with a moderate decrease above 100 °C. The performances and electrical efficiencies achieved at 110 °C (cell power density of about 400 mWcm–2 at an average cell voltage of about 0.5–0.6 V) are promising for automotive applications. Duty‐cycle and steady‐state galvanostatic experiments showed excellent stack stability for operation at high temperature. A performance comparison of AquivionTM and NafionTM‐based MEAs under practical operating conditions showed a significantly better capability for the Solvay Solexis membrane to sustain high temperature operation.Keywords
This publication has 39 references indexed in Scilit:
- Characterisation and Modelling of a High Temperature PEM Fuel Cell Stack using Electrochemical Impedance SpectroscopyFuel Cells, 2009
- Configuration effects of air, fuel, and coolant inlets on the performance of a proton exchange membrane fuel cell for automotive applicationsInternational Journal of Hydrogen Energy, 2009
- Economic & commercial viability of hydrogen fuel cell vehicles from an automotive manufacturer perspectiveInternational Journal of Hydrogen Energy, 2009
- Performance and degradation of high temperature polymer electrolyte fuel cell catalystsJournal of Power Sources, 2008
- Activity benchmarks and requirements for Pt, Pt-alloy, and non-Pt oxygen reduction catalysts for PEMFCsApplied Catalysis B: Environment and Energy, 2005
- Non-Fluorinated Polymer Materials for Proton Exchange Membrane Fuel CellsAnnual Review of Materials Research, 2003
- New polymer electrolytes based on blends of sulfonated polysulfones with polybenzimidazoleElectrochimica Acta, 2001
- On the development of proton conducting polymer membranes for hydrogen and methanol fuel cellsJournal of Membrane Science, 2001
- Comparison of Ethanol and Methanol Oxidation in a Liquid-Feed Solid Polymer Electrolyte Fuel Cell at High TemperatureElectrochemical and Solid-State Letters, 1999
- Evaluation of Ethanol, 1‐Propanol, and 2‐Propanol in a Direct Oxidation Polymer‐Electrolyte Fuel Cell: A Real‐Time Mass Spectrometry StudyJournal of the Electrochemical Society, 1995