Pressure and temperature sensors based on an over-discharged spliced polarization-maintaining photonic crystal fiber
- 9 August 2024
- journal article
- research article
- Published by Optica Publishing Group in Optics Express
- Vol. 32 (17) , 30839-30849
Abstract
A polarization maintaining-photonic crystal fiber (PM-PCF) sensor for air pressure and temperature measurement is proposed by over-discharge splicing a section of PM-PCF to a single-mode fiber. This simple splicing procedure generates an air bubble in the PM-PCF at the splicing spot. The bubble and the PM-PCF cavities cascading sensor operates on three beams interference and demonstrates an envelope in the reflection spectrum. The pressure measurement results show that the resonance wavelength is linearly red shift with the gas pressure increasing, and the pressure sensitivity is nonlinearly increasing as the bubble length increases. A maximum sensitivity of the resonance wavelength shift is 4.05 nm/MPa in the range of 0.1 ∼ 0.9 MPa obtained with a sensor sample with 65µm bubble length. This sensor also shows 25.3 times more sensitivity amplification than the non-bubble PM-PCF sensor. Besides, the sensor also shows response to temperature, in the temperature range of 25 ∼ 500°C, the maximum sensitivity with 10pm/°C is obtained. Additionally, the proposed sensor also shows good repeatability and stability. In conclusion, the simple PM-PCF sensor can be applied in high-pressure and high-temperature monitoring in harsh environments.Keywords
This publication has 27 references indexed in Scilit:
- An Ultrasensitive Gas Pressure Sensor Based on Single-Core Side-Hole Fiber With Optical Vernier EffectJournal of Lightwave Technology, 2023
- High-precision optical fiber Fabry–Perot composite sensor for pressure and temperatureOptics Communications, 2022
- High-sensitive fiber-optic pressure sensor based on Fabry-Perot interferometer filled with ultraviolet glue film and Vernier effectOptical Fiber Technology, 2021
- Optical Fiber Gas Pressure Sensor Based on Polydimethylsiloxane MicrocavityJournal of Lightwave Technology, 2021
- Three-dimensional-printed Fabry–Perot interferometer on an optical fiber tip for a gas pressure sensorApplied Optics, 2020
- Simultaneous measurement of gas pressure and temperature with integrated optical fiber FPI sensor based on in-fiber micro-cavity and fiber-tipOptical Fiber Technology, 2018
- Fiber Fabry–Pérot Interferometer for Measurement of Gas Pressure and TemperatureJournal of Lightwave Technology, 2016
- A Highly Sensitive and Low-Cost Sagnac Loop Based Pressure SensorIEEE Sensors Journal, 2013
- Fabry–Pérot Cavity Based on Hollow-Core Ring Photonic Crystal Fiber for Pressure SensingIEEE Photonics Technology Letters, 2012
- High-temperature fiber-tip pressure sensorJournal of Lightwave Technology, 2006