Effect of cutting variables on bearing area curve parameters (BAC-P) during hard turning process
Authors:
Open Access
- 1 April 2020
- journal article
- research article
- Published by Polish Academy of Sciences Chancellery in Archive of Mechanical Engineering
- Vol. 67 (1) , 73-95
Abstract
Hard turning is a machining process that is widely used in the precision mechanical industry. The characterization of the functional surface texture by the ISO 13565 standard holds a key role in automotive mechanics. Until now, the impact of cutting conditions during hard turning operation on the bearing area curve parameters has not been studied (ISO 13565). The three parameters Rpk , Rk and Rvk illustrate the ability of the surface texture to resist friction. In this work, the main objective is to study the impact of cutting conditions (Vc, f and ap) of the hard turning on three parameters of the bearing area curve. The statistical study based on response surface methodology (RSM), analysis of variance (ANOVA) and quadratic regression were performed to model the three output parameters and optimize the input parameters. The experimental design used in this study is the Taguchi L25 orthogonal array. The results obtained show that the cutting speed has a greater effect on the bearing ratio curve (Rpk , Rk and Rvk ) parameters with a percentage contribution of 37.68%, 37.65% and 36.91%, respectively. The second significant parameter is the feed rate and the other parameter is significant only in relation to Rpk and Rk parameters.Keywords
This publication has 40 references indexed in Scilit:
- Prediction of surface roughness and cutting forces using RSM, ANN, and NSGA-II in finish turning of AISI 4140 hardened steel with mixed ceramic toolThe International Journal of Advanced Manufacturing Technology, 2018
- Design optimization for minimum technological parameters when dry turning of AISI D3 steel using Taguchi methodThe International Journal of Advanced Manufacturing Technology, 2016
- Investigation and modeling of cutting forces and surface roughness when hard turning of AISI 52100 steel with mixed ceramic tool: cutting conditions optimizationThe International Journal of Advanced Manufacturing Technology, 2014
- Machinability investigation in hard turning of AISI D3 cold work steel with ceramic tool using response surface methodologyThe International Journal of Advanced Manufacturing Technology, 2014
- Relevance of roughness parameters of surface finish in precision hard turningScanning, 2013
- Surface roughness and cutting forces modeling for optimization of machining condition in finish hard turning of AISI 52100 steelJournal of Mechanical Science and Technology, 2012
- Influence of cutting parameters on tool wear and surface roughness in hard turning of AISI H11 tool steel using ceramic toolsInternational Journal of Precision Engineering and Manufacturing, 2012
- Tool wear, chip formation and workpiece surface issues in CBN hard turning: A reviewInternational Journal of Precision Engineering and Manufacturing, 2010
- The effect of abrasive grain's wear and contact conditions on surface texture in belt finishingWear, 2007
- Comparative assessment of surface roughness produced by hard machining with mixed ceramic tools including 2D and 3D analysisJournal of Materials Processing Technology, 2005