Effect of Cu and Zr Additions on the Superplastic Behavior of 6061 Aluminum Alloy
Authors:
- 1 January 2002
- journal article
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 43 (10) , 2392-2399
Abstract
Experiments were conducted to evaluate the influence of zirconium and copper additions on superplastic behavior of a 6061 aluminum alloy. Fine grains were produced in a commercial grade of 6061 Al and a 0.15%Zr+0.7%Cu-modified 6061 alloy by two-step thermomechanical processing. The superplastic properties and microstructure evolution of both alloys were examined in tension at temperatures ranging from 475 to 620°C and strain rates ranging from 7×10−6 to 2.8×10−2 s−1. It was shown using differential thermal analysis that both alloys exhibit the highest superplastic characteristics in a partially melted state. The 0.15%Zr+0.7%Cu-modified 6061 aluminum alloy exhibits a maximum elongation-to-failure of 1300% at 590°C and an initial strain rate of 2.8×10−4 s−1. In contrast, the highest total elongation of 350% (m∼0.6) was achieved in the commercial grade 6061 alloy at 600°C and a strain rate of 1.4×10−4 s−1. The results suggest the addition of Zr provides high stability of the fine-grained structure under superplastic deformation at high temperatures by precipitation of Al3Zr dispersoids. Apparently, the increased amount of liquid phase caused by the copper addition can enhance the superplastic properties of the 6061 alloy.Keywords
This publication has 15 references indexed in Scilit:
- Effect of liquid phase on superplastic behavior of a modified 6061 aluminum alloyScripta Materialia, 2002
- Microstructural and mechanical characterization of a superplastic 6xxx aluminum alloyMaterials Science and Engineering: A, 2000
- Effects of the liquid phase on the high-temperature tensile ductility: From embrittlement to superplasticityPhilosophical Magazine A, 1998
- High strain rate superplasticity in a continuously recrystallized Al–6%Mg–0.3%Sc alloyActa Materialia, 1998
- Critical assessments of accommodation process by liquid phase for superplastic flow in Si3N4/Al–Mg–Si metal matrix compositesJournal of Materials Research, 1997
- Effect of liquid phases on the tensile elongation of superplastic aluminum alloys and compositesScripta Metallurgica et Materialia, 1995
- In situ observation of partial melting in superplastic aluminum alloy composites at high temperaturesActa Metallurgica et Materialia, 1995
- Superplastic deformation mechanism accommodated by the liquid phase in metal matrix compositesPhilosophical Magazine Letters, 1994
- Superplasticity of AlMgSi alloysJournal of Materials Science, 1992
- Mechanical behaviour of an aluminium alloy with fusible grain boundariesScripta Metallurgica et Materialia, 1992