Parameter study of stretch—blow moulding process of polyethylene terephthalate bottles using finite element simulation
Authors:
- 4 February 2010
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 224 (8) , 1217-1227
Abstract
In this paper, the analysis of the stretch—blow moulding (SBM) process of polyethylene terephthalate (PET) bottles is studied by the finite element method (FEM). In this simulation, owing to the symmetry of bottle geometry, the parts are considered as an axisymmetric model. A hyperelastic constitutive behaviour was calibrated using material data available in literature in variant high temperatures and strain rates and was used in the numerical simulation. Hydrostatic pressure with convention heat transfer has been used instead of a blowing process. Comparisons of numerical results with experimental observations demonstrate that the model can predict an overall trend of thickness distribution, especially in regions between 30 mm to 90 mm from the bottle bottom. However, some differences can be seen in regions 10 mm and 125 mm. These results can be used for an overall prediction of bottle properties such as final bottle thickness and a defect-free production because they are governed by orientation and crystallinity, which are highly temperature and strain dependent. Also, with definition of the critical area in bottle forming, the parametric studies are conducted on the effect of friction condition, heat transfer coefficient, and initial pre-blowing air entrance time delay on bottle thickness. Through the study, it becomes clear that the proposed model is applicable for simulating the stretch-blow moulding process of PET bottles, and is capable of offering helpful knowledge in the production of bottles and the design of an optimum preform.Keywords
This publication has 12 references indexed in Scilit:
- Stress–strain behaviour of poly(ethylene terephthalate) (PET) during large plastic deformation by plane strain compression: the relation between stress–strain curve and thermal history, temperature and strain rateRheologica Acta, 2005
- Modeling and simulation of stretch blow molding of polyethylene terephthalatePolymer Engineering & Science, 2004
- Modelling of poly(ethylene terephthalate) in injection stretch–blow mouldingPlastics, Rubber and Composites: Macromolecular Engineering, 2000
- A visco-hyperelastic approach to modelling the constitutive behaviour of rubberInternational Journal of Impact Engineering, 2000
- Experimental study and numerical simulation of the injection stretch/blow molding processPolymer Engineering & Science, 1998
- Viscoelastic simulation of PET stretch/blow molding processJournal of Non-Newtonian Fluid Mechanics, 1996
- Some Forms of the Strain Energy Function for RubberRubber Chemistry and Technology, 1993
- Finite element modeling of the time‐dependent behavior of nonlinear ductile polymersPolymer Engineering & Science, 1992
- Computer simulation of thermoforming in complex shapesPolymer Engineering & Science, 1992
- The application of an exponential‐type function for the modeling of viscoelasticity of solid polymersPolymer Engineering & Science, 1992