Elevated re-aging of a piston aluminium alloy and effect on the microstructure and mechanical properties
Authors:
- Lusha TianLTLusha Tian
- Yongchun GuoYGYongchun Guo
- Jianping LiJLJianping Li
- Jianli WangJWJianli Wang
- Hongbo DuanHDHongbo Duan
- Feng XiaFXFeng Xia
- Minxian LiangMLMinxian Liang
- 1 December 2018
- journal article
- research article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 738, 375-379
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- High Temperature Fatigue Behavior of Eutectic Al-Si-Alloys Used for Piston ProductionProcedia Engineering, 2014
- Ab initio interface configuration determination for β″ in Al–Mg–Si: Beyond the constraint of a preserved precipitate stoichiometryComputational Materials Science, 2014
- Formation of nanoporous copper through dealloying of dual-phase Cu–Mn–Al alloy: The evolution of microstructure and compositionJournal of Materials Research, 2012
- Thermal analysis and microscopic characterization of the piston alloy AlSi13Cu4Ni2MgIntermetallics, 2011
- The heat treatment of Al–Si–Cu–Mg casting alloysJournal of Materials Processing Technology, 2010
- Coupled dynamic–multidimensional modelling of free-piston engine combustionApplied Energy, 2009
- The effect of heat-treatment on aluminum-based piston alloysMaterials & Design (1980-2015), 2007
- Comparison among chemical and electromagnetic stirring and vibration melt treatments for Al–Si hypereutectic alloysJournal of Alloys and Compounds, 2006
- Fluidized bed heat treatment of cast Al-Si-Cu-Mg alloysMetallurgical and Materials Transactions A, 2006
- Elevated temperature short crack fatigue behaviour in near eutectic Al?Si alloysInternational Journal of Fatigue, 2003