Failure Analysis of Printed Circuit Board Solder Joint under Thermal Shock
Open Access
Abstract
Investigating the failure mechanism of solder joints under different temperature conditions is significant to ensure the service life of a printed circuit board (PCB). In this research, the stress and strain distribution of a PCB solder joint was evaluated by high- and low-temperature thermal shock tests. The cross-section of the solder joint after thermal shock testing was measured using a 3D stereoscopic microscope and SEM equipped with EDS. The microstructure of the lead-free solder joint and the phase of the intermetallic compound (IMC) layer were studied by XRD. The working state of the PCB solder joint under thermal shock was simulated and analyzed by the finite element method. The results show that thermal shock has a great effect on the reliability of solder joints. The location of the actual crack is consistent with the maximum stress–strain concentration area of the simulated solder joint. The brittle Cu6Sn5 and Cu3Sn phases at the interface accelerate the failure of solder joints. Limiting the growth of Cu6Sn5 and Cu3Sn phases can improve the reliability of solder joints to a certain extent.Keywords
Funding Information
- Shanghai Motor Vehicle Inspection Certification & Tech Innovation Center Co., Ltd., Jiangsu Provincial Natural Science Fund Research Project (BK20211344, 2018XCL-028, KYCX21_3451)
- Jiangsu provincial Six Talent Peaks (BK20211344, 2018XCL-028, KYCX21_3451)
- Jiangsu Provincial Postgraduate Research & Practice Innovation Program (BK20211344, 2018XCL-028, KYCX21_3451)
This publication has 42 references indexed in Scilit:
- The orientation relationships of the Cu3Sn/Cu interfaces and a discussion of the formation sequence of Cu3Sn and Cu6Sn5Thin Solid Films, 2014
- Mechanical and corrosion resistances of a Sn–0.7wt.%Cu lead-free solder alloyMicroelectronics Reliability, 2014
- Corrosion measurement of Sn–Zn lead-free solders in 6 M KOH solutionMeasurement, 2014
- The influence of addition of nanosized molybdenum and nickel particles on creep behavior of Sn–Ag lead free solder alloyJournal of Alloys and Compounds, 2012
- A review on thermal cycling and drop impact reliability of SAC solder joint in portable electronic productsMicroelectronics Reliability, 2012
- Elastic properties and thermal behavior of Sn–Zn based lead-free solder alloysJournal of Alloys and Compounds, 2010
- Effect of Bi addition on the activation energy for the growth of Cu5Zn8 intermetallic in the Sn–Zn lead-free solderIntermetallics, 2010
- Mechanical properties of QFP micro-joints soldered with lead-free solders using diode laser soldering technologyTransactions of Nonferrous Metals Society of China, 2008
- A study of nanoparticles in Sn–Ag based lead free soldersMicroelectronics Reliability, 2008
- Thermomechanical fatigue damage evolution in SAC solder jointsMaterials Science and Engineering: A, 2007