Experimental investigation of WEDM process through integrated desirability and machine learning technique on implant material
Authors:
Open Access
- 1 January 2021
- journal article
- research article
- Published by Walter de Gruyter GmbH in Journal of the Mechanical Behavior of Materials
- Vol. 30 (1) , 38-48
Abstract
CP-Ti G2 has become the preferred biocompatible material for various devices mainly used in orthopedic and dental implants and it is also used in aviation and aircraft. While CP-Ti G2 deals with good ductility, higher stiffness, and fatigue resistance. The novelty of present research work was attentive to the effect of WEDM factors on MRR. After machining, surface topography was examined through SEM. MRR was modeled through ANOVA to analyze the adequacy. It was observed that POT, POFT, PC, and SGV most significant factors. The WEDM factors have also been significantly deteriorating the morphology of machined samples in the form of craters, debris, and micro cracks. A multi-objective optimization ‘desirability’ function hybrid with a supervised machine learning algorithm was applied to obtain the optimal solutions. The results show a good agreement between actual and predicted values.Keywords
This publication has 27 references indexed in Scilit:
- Surface integrity and material transfer investigation of pure titanium for rough cut surface after wire electro discharge machiningProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- Modeling and Optimization of Medium-Speed WEDM Process Parameters for Machining SKD11Materials and Manufacturing Processes, 2013
- Effect of Wire-EDM Machining Parameters on Surface Roughness and Material Removal Rate of High Strength Armor SteelMaterials and Manufacturing Processes, 2013
- Optimization of surface roughness and thickness of white layer in wire electrical discharge machining of DIN 1.4542 stainless steel using micro-genetic algorithm and signal to noise ratio techniquesProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2012
- Optimizing surface finish in WEDM using the taguchi parameter design methodJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2010
- Modelling and optimization of process parameters of wire electrical discharge machiningProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2009
- Biomedical applications of titanium and its alloysJOM, 2008
- Parametric analysis and optimization of wire electrical discharge machining of γ-titanium aluminide alloyJournal of Materials Processing Technology, 2005
- Titanium alloys in total joint replacement—a materials science perspectiveBiomaterials, 1998
- Tribological properties of titanium alloysWear, 1991