Effect of annealing on the laser induced damage of polished and CO2 laser-processed fused silica surfaces
Authors:
- 7 June 2016
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 119 (21) , 213106
Abstract
We investigate the effect of different heat treatments on the laser-induced damage probabilities of fused silica samples. Isothermal annealing in a furnace is applied, with different temperatures in the range 700–1100 °C and 12 h annealing time, to super-polished fused silica samples. The surface flatness and laser damage probabilities at 3 ns, 351 nm are measured before and after the different annealing procedures. We have found a significant improvement of the initial laser damage probabilities of the silica surface after annealing at 1050 °C for 12 h. A similar study has been conducted on CO2 laser-processed sites on the surface of the samples. Before and after annealing, we have studied the morphology of the sites, the evolution of residual stress, and the laser-induced damage threshold measured at 351 nm, 3 ns. In this case, we observe that the laser damage resistance of the laser created craters can reach the damage level of the bare fused silica surface after the annealing process, with a complete stress relieve. The obtained results are then compared to the case of local annealing process by CO2 laser irradiation during 1 s, and we found similar improvements in both cases. The different results obtained in the study are compared to numerical simulations made with a thermo-mechanical model based on finite-element method that allows the simulation of the isothermal or the local annealing process, the evolution of stress and fictive temperature. The simulation results were found to be very consistent with experimental observations for the stresses evolution after annealing and estimation of the heat affected area during laser-processing based on the density dependence with fictive temperature. Following this work, the temperature for local annealing should reach 1330–1470 °C for an optimized reduction of damage probability and be below the threshold for material removal, whereas furnace annealing should be kept below the annealing point to avoid sample deformation.Keywords
This publication has 50 references indexed in Scilit:
- Evaluation of the fused silica thermal conductivity by comparing infrared thermometry measurements with two-dimensional simulationsApplied Physics Letters, 2012
- The Structure Evolution of Fused Silica Induced by CO 2 Laser IrradiationChinese Physics Letters, 2012
- Infrared thermometry and interferential microscopy for analysis of crater formation at the surface of fused silica under CO2 laser irradiationJournal of Applied Physics, 2012
- CO2激光及后热处理技术对熔石英表面损伤增长系数的影响Chinese Optics Letters, 2011
- Comparing the use of mid-infrared versus far-infrared lasers for mitigating damage growth on fused silicaApplied Optics, 2010
- Accurate measurements of laser-induced bulk damage densityMeasurement Science and Technology, 2009
- Structural modification of silica glass by laser scanningJournal of Applied Physics, 2004
- Structural Change in the Near-Surface of a Silica Glass Block by Heat TreatmentJournal of the Ceramic Society of Japan, 1998
- Carbon dioxide laser polishing of fused silica surfaces for increased laser-damage resistance at 1064 nmApplied Optics, 1982
- RELATION BETWEEN INELASTIC DEFORMABILITY AND THERMAL EXPANSION OF GLASS IN ITS ANNEALING RANGE*Journal of the American Ceramic Society, 1946