Detection and Modeling of Timing Errors at Seismic Arrays
Author:
Open Access
- 1 September 2026
- journal article
- Published by Seismological Society of America (SSA) in Seismological Research Letters
- Vol. 97 (5) , 2890-2898
Abstract
Accurate timing is both an essential requirement and a perennial problem for seismology. With the adoption of satellite-based global positioning systems for the timestamping of data in the 1990s, this problem appeared to have been solved. There is, nonetheless, still a need for techniques for in situ verification of timing, and keen investigators continue to turn up issues. I have applied multi-channel cross-correlation (VanDecar and Crosson, 1990) to recordings of teleseisms across seismic arrays, followed by empirical moveout correction, to estimate the relative timing error between array elements. At the Yellowknife Seismological Array, timing errors are observed at some array elements, up to a maximum of 0.4 s, whereas others exhibit no apparent timing errors. The relative timing errors between 2014 and 2020 were quantized, with a base value of 0.125 s, exactly five samples at 40 samples per second. The timing errors have random onset and only increase until the datalogger is reset. This quantization is inconsistent with what is expected for a free-running clock, and no timing errors have been observed since a digitizer firmware upgrade on 8 April 2020. Because of the quantization, and because the error only increases between clock resynchronizations, it is possible to make a table of time spans and timing errors for each element—a model—that can be used to correct the timing of recorded waveforms. It is recommended that operators of other seismic arrays periodically use similar methods to check for timing errors.Keywords
This publication has 19 references indexed in Scilit:
- Inner core backtracking by seismic waveform change reversalsNature, 2024
- Evaluating and correcting short-term clock drift in data from temporary seismic deploymentsEarthquake Research Advances, 2023
- Origin of temporal changes of inner-core seismic wavesEarth and Planetary Science Letters, 2020
- Identifying and Correcting Timing Errors at Seismic Stations in and around IranSeismological Research Letters, 2017
- ObsPy: a bridge for seismology into the scientific Python ecosystemComputational Science & Discovery, 2015
- Traveltime measurements from noise correlation: stability and detection of instrumental time-shiftsGeophysical Journal International, 2007
- The detection and location of low magnitude earthquakes in northern Norway using multi-channel waveform correlation at regional distancesPhysics of the Earth and Planetary Interiors, 2007
- The detection of low magnitude seismic events using array-based waveform correlationGeophysical Journal International, 2006
- A Double-Difference Earthquake Location Algorithm: Method and Application to the Northern Hayward Fault, CaliforniaBulletin of the Seismological Society of America, 2000
- Constraints on seismic velocities in the Earth from traveltimesGeophysical Journal International, 1995