Virtual Process Using LabVIEW in Combination with Modbus TCP for Fieldbus Control System
Authors:
- 1 November 2019
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 21-24
Abstract
This paper presents a design and implementation of virtual process using LabVIEW in combination with Modbus TCP protocol for fieldbus control system (FCS). A level virtual process has been simulated in LabVIEW supported by NI input/output broad (NI - myDAQ), providing the 0-5V analog input and output signals. It is used to control actuators and to read data from sensors of the simulated process. Arduino broads incorporated with Ethernet shields are the Modbus TCP/voltage converter, communicating the data between programmable logic controller (PLC) that acts like a client and Arduino servers. Therefore, the virtual process can be controlled by the real PLC, and can be monitored by the real monitoring system over TCP/IP network. The experimental results show that the data communication among all devices works well. The mean absolute percentage error between both processes is less than 5.24%. In addition, the proposed model is very flexible and low cost. Hence, it is suitable for teaching and training.Keywords
This publication has 6 references indexed in Scilit:
- Process simulation platform for virtual manufacturing systems evaluationComputers in Industry, 2019
- Online Monitoring and Control of Flow rate in Oil Pipelines Transportation System by using PLC based Fuzzy‐PID ControllerFlow Measurement and Instrumentation, 2018
- Retracted: Research on Virtual Simulation of Whole Process Teaching of Thermal Power Project2017
- Design of virtual process control laboratory (VPCL) using first principle method and interactive PID control toolkit using Labview2017
- Integrating low cost platforms on electrical power systems for control and condition monitoring2016
- Introduction to Industrial Control NetworksIEEE Communications Surveys & Tutorials, 2012