A comparison of two-dimensional and three-dimensional flow structures over artificial pool-riffle sequences
Authors:
- 1 December 2017
- journal article
- research article
- Published by Canadian Science Publishing in Canadian Journal of Civil Engineering
- Vol. 44 (12) , 1084-1098
Abstract
Experiments have been carried out in a flume with one 2D pool-riffle sequence and one 3D pool-riffle sequence, respectively. Objectives of this study are to determine whether or not the convergence of lateral flow exists. Variations of the near-bed shear stress have been studied. The characteristics of the secondary currents along a pool-riffle sequence have been investigated. Results showed that for the 3D pool-riffle sequence, the near-bed velocity decreases along convective deceleration flow (CDF) and increases along convective acceleration flow (CAF), respectively. It is found that the shear velocities estimated from the slope of the velocity gradient in the inner layer, decrease in the CDF section, and increase in the CAF section in the 3D pool-riffle sequences. The Reynolds shear stress is highest at the CDF section along longitudinal lines with distances of 10 cm and 20 cm away from the channel wall.Keywords
This publication has 43 references indexed in Scilit:
- Flow and turbulence redistribution in a straight artificial poolWater Resources Research, 2012
- Coherent structures in turbulent boundary layers with adverse pressure gradientsJournal of Turbulence, 2010
- The linkage between velocity patterns and sediment entrainment in a forced‐pool and riffle unitEarth Surface Processes and Landforms, 2008
- Phase‐shifts in shear stress as an explanation for the maintenance of pool–riffle sequencesEarth Surface Processes and Landforms, 2004
- An experimental study of turbulent flow over a low‐angle duneJournal of Geophysical Research: Oceans, 2002
- Modelling three‐dimensional flow structures and patterns of boundary shear stress in a natural pool–riffle sequenceEarth Surface Processes and Landforms, 2001
- The effects of a favourable pressure gradient and of the Reynolds number on an incompressible axisymmetric turbulent boundary layer. Part 1. The turbulent boundary layerJournal of Fluid Mechanics, 1998
- Turbulence characteristics of a boundary layer over a two-dimensional bumpJournal of Fluid Mechanics, 1996
- TURBULENCE CHARACTERISTICS IN ROUGH NON-UNIFORM OPEN-CHANNEL FLOW.Proceedings of the Institution of Civil Engineers - Water, Maritime and Energy, 1995
- Rough-wall boundary layers in adverse pressure gradientsJournal of Fluid Mechanics, 1963