Tensile Deformation of B19′ Martensite in Nanocrystalline NiTi Wires
Open Access
- 22 February 2023
- journal article
- research article
- Published by Springer Nature in Shape Memory and Superelasticity
- Vol. 9 (1) , 11-34
Abstract
Deformation mechanisms activated during tensile deformation of nanocrystalline NiTi wire in martensite state were investigated by combination of two experimental methods: (i) analysis of the evolution of martensite-variant microstructures in grains of deformed wire by TEM and (ii) analysis of the evolution of martensite texture by in situ synchrotron X-ray diffraction. The obtained results are linked to the activity of various twinning processes in martensite. It is concluded that martensite reorientation proceeds via motion of interdomain interfaces, gives rise to reoriented martensite with microstructure consisting of single (001) compound-twinned domain in each grain and results in sharp two-fiber texture of the martensite. The reorientation process leaves behind only very small unrecovered strains and very few dislocation defects in the austenitic microstructure of the deformed wire after unloading and heating. Plastic deformation of B19′ martensite proceeds via peculiar deformation mechanism which combines (100) deformation twinning with [100]/(011) dislocation slip based kinking. It gives rise to very special martensite variant microstructures consisting of deformation twin bands and kink bands containing martensite lattice aligned with [010] direction and characteristic two-fiber martensite texture. Reverse martensitic transformation of plastically deformed martensite upon unloading and heating leaves behind large unrecovered strains and high density of lattice defects in austenite. But there are also significant recoverable strains up to 10%. While the martensite matrix in grains of plastically deformed wire transforms into parent austenite matrix, (20-1) deformation twins transform into {114} austenite twins.Keywords
This publication has 52 references indexed in Scilit:
- Micromechanical quantification of elastic, twinning, and slip strain partitioning exhibited by polycrystalline, monoclinic nickel–titanium during large uniaxial deformations measured via in-situ neutron diffractionJournal of the Mechanics and Physics of Solids, 2013
- On elastic moduli and elastic anisotropy in polycrystalline martensitic NiTiActa Materialia, 2011
- Neutron diffraction studies and multivariant simulations of shape memory alloys: Empirical texture development–mechanical response relations of martensitic nickel–titaniumActa Materialia, 2011
- A novel pole figure inversion method: specification of theMTEXalgorithmJournal of Applied Crystallography, 2008
- Deformation mechanism of martensite in Ti-rich Ti–Ni shape memory alloy thin filmsActa Materialia, 2006
- The self-accommodated morphology of martensite in nanocrystalline NiTi shape memory alloysActa Materialia, 2005
- Constitutive equations for martensitic reorientation and detwinning in shape-memory alloysJournal of the Mechanics and Physics of Solids, 2005
- Direct evidence of correlation between ?201?B19′ and ?114?B2 deformation twins in Ti–Ni shape memory alloyScripta Materialia, 2003
- A lattice-based model of the kinetics of twin boundary motionJournal of the Mechanics and Physics of Solids, 2003
- On the deformation of the twinned domain in Niti shape memory alloysPhilosophical Magazine A, 2000