Surface damages and tool wear mode in end milling of hastelloy‐C276 under dry and wet conditions
Authors:
- 15 December 2016
- journal article
- research article
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 47 (12) , 1182-1192
Abstract
Hastelloy‐C276 is a nickel based superalloy that is widely used in chemical, petro‐chemical, environmental and nuclear industries due to its outstanding performance in a wide range of corrosive mediums. The superior properties of nickel based superalloys impair their machinability which increases the difficulty in obtaining a good surface finish. Because most of the components' failures are initiated from surface defects, several researchers have been concerned about surface integrity in machining aerospace superalloys particularly Inconel‐718. Due to the lack of studies done on machining corrosion‐resistant superalloys, this study aims to investigate surface damages and tool wear modes in milling Hastelloy‐C276 under dry and wet conditions. The absence of cooling and lubricating actions in dry machining resulted in the formation of craters, severe plastic deformation, voids, debris re‐deposition and materials drag. The breakage of the nucleated carbide phases resulted in the formation of nucleated cavities on the machined surface in both wet and dry machining. Adhesive tool wear was less in dry machining due to the formation of oxide layers on tool faces which suppressed the formation of built‐up edges due to the weak adhesion properties of oxide compounds which resulted in less surface roughness at vc = 50 m/min. On the other hand, the higher temperature and friction in dry machining resulted in severer tool coating delamination.Keywords
This publication has 31 references indexed in Scilit:
- Tool wear characteristics in machining of nickel-based superalloysInternational Journal of Machine Tools and Manufacture, 2013
- An investigation of surface damage in the high speed turning of Inconel 718 with use of whisker reinforced ceramic toolsJournal of Materials Processing Technology, 2012
- Dry machining of Inconel 718, workpiece surface integrityJournal of Materials Processing Technology, 2011
- Study on surface damages caused by turning NiCr20TiAl nickel-based alloyJournal of Materials Processing Technology, 2009
- Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718International Journal of Machine Tools and Manufacture, 2008
- Modeling tool wear progression by using mixed effects modeling technique when end-milling AISI 4340 steelJournal of Materials Processing Technology, 2007
- An investigation of cutting forces and surface damage in high-speed turning of Inconel 718Journal of Materials Processing Technology, 2007
- Turning of advanced Ni based alloys obtained via powder metallurgy routeCIRP Annals, 2006
- Residual stress and surface roughness when facing age hardened Inconel 718 with CBN and ceramic cutting toolsInternational Journal of Machine Tools and Manufacture, 2004
- Cutting temperature of ceramic tools in high speed machining of difficult-to-cut materialsInternational Journal of Machine Tools and Manufacture, 1996