Development of a smart RFID-based corrosion sensor
Authors:
- 1 October 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19300395,p. 534-537
Abstract
The development and test of a smart RFID-based corrosion sensor is presented. The sensor has a small size (5 cm × 3 cm × 1.8 cm) allowing it to be embedded in concrete or other construction materials. The corrosion sensor is built around a low-power microcontroller which enables multiple and complex measurements to take place. The sensor is totally passive and it does not require batteries. Its power supply is derived from an electromagnetic field transmitted by an external RFID reader. This field is also used for data communication. The sensor contains a potentiostat that is used to perform linear polarization measurements on a corrosion cell. The sensor can also measure temperature and its own supply voltage. Unlike existing embeddable corrosion sensors, the developed sensor can acquire full polarization curves with a resolution of 10 bits. The sensor can communicate with ISO-15693 compliant RFID readers.Keywords
This publication has 8 references indexed in Scilit:
- Unpowered Wireless Corrosion Sensor for Steel Reinforced Concrete2006
- Smart Pebble: wireless sensors for structural health monitoring of bridge decks2003
- Half-cell potential measurements—Potential mapping on reinforced concrete structuresMaterials and Structures, 2003
- Chloride-induced corrosion on reinforcing steel: from the fundamentals to the monitoring techniquesCement and Concrete Composites, 2003
- On-site measurements of corrosion rate of reinforcementsConstruction and Building Materials, 2001
- Effect of protective oxide scales in the macrogalvanic behaviour of concrete reinforcementsCorrosion Science, 1998
- Recording and Analysis of AC Impedance Data for Corrosion StudiesCorrosion, 1981
- Closure to “Discussion of ‘Electrochemical Polarization, 1. A Theoretical Analysis of the Shape of Polarization Curves’ [M. Stern and A. L. Geary (pp. 56–63, Vol. 104)]”Journal of the Electrochemical Society, 1957