Elliptical pore regularisation of the inverse problem for microstructured optical fibre fabrication
- 30 July 2015
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 778, 5-38
Abstract
A mathematical model is presented describing the deformation, under the combined effects of surface tension and draw tension, of an array of channels in the drawing of a broad class of slender viscous fibres. The process is relevant to the fabrication of microstructured optical fibres, also known as MOFs or holey fibres, where the pattern of channels in the fibre plays a crucial role in guiding light along it. Our model makes use of two asymptotic approximations, that the fibre is slender and that the cross-section of the fibre is a circular disc with well-separated elliptical channels that are not too close to the outer boundary. The latter assumption allows us to make use of a suitably generalised ‘elliptical pore model (EPM)’ introduced previously by one of the authors (Crowdy, J. Fluid Mech., vol. 501, 2004, pp. 251–277) to quantify the axial variation of the geometry during a steady-state draw. The accuracy of the elliptical pore model as an approximation is tested by comparison with full numerical simulations. Our model provides a fast and accurate reduction of the full free-boundary problem to a coupled system of nonlinear ordinary differential equations. More significantly, it also allows a regularisation of an important ill-posed inverse problem in MOF fabrication: how to find the initial preform geometry and the experimental parameters required to draw MOFs with desired cross-plane geometries.Keywords
This publication has 37 references indexed in Scilit:
- Predicting hole sizes after fibre drawing without knowing the viscosityOptical Materials Express, 2013
- Boundary integral method for the evolution of slender viscous fibres containing holes in the cross-sectionJournal of Fluid Mechanics, 2009
- Mathematical modelling of non-axisymmetric capillary tube drawingJournal of Fluid Mechanics, 2008
- The mathematical modelling of rotating capillary tubes for holey-fibre manufactureJournal of Engineering Mathematics, 2007
- An elliptical-pore model for late-stage planar viscous sinteringJournal of Fluid Mechanics, 2004
- Computation of the pressure inside bubbles and pores in Stokes flowJournal of Fluid Mechanics, 2003
- Expansion of a compressible gas bubble in Stokes flowJournal of Fluid Mechanics, 2001
- Integral method for a two-dimensional Stokes flow with shrinking holes applied to viscous sinteringJournal of Fluid Mechanics, 1993
- Plane Stokes flow driven by capillarity on a free surfaceJournal of Fluid Mechanics, 1990
- Spinning a Molten Threadline. StabilityIndustrial & Engineering Chemistry Fundamentals, 1969