Effect of transparent substrate on properties of CuInSe2 thin films prepared by chemical spray pyrolysis
Open Access
- 30 August 2022
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-12
Abstract
In this paper, the properties of CuInSe2(CISe) films deposited on three transparent substrates (FTO, FTO/NiOx, FTO/MoO3) are studied. These substrates might be used for bifacial solar cells, in place of the conventional glass/Mo substrates. CISe layers are deposited by spray pyrolysis followed by a selenization process. For the same deposition conditions, the CISe layers on FTO show the largest grain size (~ 0.50 µm) and crystallinity, while FTO/MoO3substrates result in the smallest grains (~ 0.15 µm). The optical bandgap of the CISe films ranged from 1.35 eV for FTO substrate to 1.44 eV for FTO/MoO3substrate. All films show p-type conductivity, with the carrier densities of 1.6 × 1017 cm−3, 5.4 × 1017 cm−3, and 2.4 × 1019 cm−3for FTO, FTO/NiOx, and FTO/MoO3substrates, respectively. The CISe films also show different conduction, and valence levels, based on the substrate. In all cases, an ohmic behavior is observed between the CISe and substrate. The results demonstrate that CISe layer crystallinity, carrier concentration, mobility, and energy levels are strongly dependent on the chemical nature of the substrate. Bare FTO shows the most appropriate performance in terms of device requirements.Keywords
This publication has 99 references indexed in Scilit:
- Prepare dispersed CIS nano-scale particles and spray coating CIS absorber layers using nano-scale precursorsDiscover Nano, 2014
- Pulsed electrodeposition of p-type CuInSe2 thin filmsElectrochimica Acta, 2011
- Electrodeposition of indium onto Mo/Cu for the deposition of Cu(In,Ga)Se2 thin filmsElectrochimica Acta, 2008
- Effects of heat treatments on the properties of Cu(In,Ga)Se2 nanoparticlesSolar Energy Materials and Solar Cells, 2007
- Microstructural and diffusion properties of CIGS thin film solar cells fabricated using transparent conducting oxide back contactsThin Solid Films, 2005
- Cu(In1-x, Gax)Se2-Based Thin Film Solar Cells Using Transparent Conducting Back ContactsJapanese Journal of Applied Physics, 2002
- Electrodeposited CdS on CIS pn junctionsSolar Energy Materials and Solar Cells, 1999
- Influence of substrates on the electrical properties of Cu(In,Ga)Se2 thin filmsSolar Energy Materials and Solar Cells, 1996
- Preparation and properties of CuInS2 thin filmsSolar Energy Materials and Solar Cells, 1994
- Defect level identification in copper indium selenide (CuInSe2) from photoluminescence studiesChemistry of Materials, 1990