A 0.52 μW, 38 nV/√Hz Chopper Amplifier With a Low-Noise DC Servo Loop, an Embedded Ripple Reduction Loop, and a Squeezed Inverter Stage
- 17 December 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 68 (6) , 1793-1797
Abstract
To realize an ultralow-power, low-noise amplifier for bio-potential recording, we investigate three design techniques. The first technique uses a noise-efficient squeezed inverter (SQI) stage biased at the supply of the 2VDSAT saturation limit. The challenge of interfacing the SQI stage with such a low supply is addressed by proposing a new capacitively-coupled chopper instrumentation amplifier (CCIA) with a low-noise DC servo loop (L-DSL) and an embedded ripple reduction loop (E-RRL). The second technique is reducing the high noise contribution of the conventional DSL. The proposed L-DSL reduces the inputreferred noise (IRN) by removing the charge dividing effect. The proposed E-RRL inserted inside the gain stage cancels the offset and achieves a ripple suppression without loading the output. The CCIA is implemented using a 0.18 μm CMOS process. The measured results show that the L-DSL successfully creates a sub-Hz high-pass corner needed to block the electrode offset. The ERRL achieves a ripple suppression of 39 dB. The CCIA achieves 32 nV/Hz noise density, which is slightly increased to 38 nV/Hz when the L-DSL is enabled. The integrated noise over 800 Hz bandwidth is 0.9 and 1.1 μVrms without and with the L-DSL, respectively. The mid-band gain of 39.6 dB is achieved by consuming 0.52 μW. These results correspond to a favorable noise efficiency factor (NEF) of 2.1 and a power efficiency factor (PEF) of 1.2.Keywords
Funding Information
- National Research Foundation of Korea (2018R1A2A2A05018621, 2020M3H2A1076786)
This publication has 12 references indexed in Scilit:
- An Ultra-High Input Impedance Analog Front End Using Self-Calibrated Positive FeedbackIEEE Journal of Solid-State Circuits, 2018
- A Noise-Efficient 36 nV/ $\surd $ Hz Chopper Amplifier Using an Inverter-Based 0.2-V Supply Input StageIEEE Journal of Solid-State Circuits, 2017
- A High Dynamic-Range Neural Recording Chopper Amplifier for Simultaneous Neural Recording and StimulationIEEE Journal of Solid-State Circuits, 2017
- A low-power chopper bandpass amplifier for biopotential sensors2016
- A 0.5-V 1.3- $\mu\text{W}$ Analog Front-End CMOS CircuitIEEE Transactions on Circuits and Systems II: Express Briefs, 2016
- A $160~\mu {\rm W}$ 8-Channel Active Electrode System for EEG MonitoringIEEE Transactions on Biomedical Circuits and Systems, 2011
- A 0.013 ${\hbox {mm}}^{2}$, 5 $\mu\hbox{W}$, DC-Coupled Neural Signal Acquisition IC With 0.5 V SupplyIEEE Journal of Solid-State Circuits, 2011
- A 1.8 $\mu$W 60 nV$/\surd$Hz Capacitively-Coupled Chopper Instrumentation Amplifier in 65 nm CMOS for Wireless Sensor NodesIEEE Journal of Solid-State Circuits, 2011
- A 2 $\mu\hbox{W}$ 100 nV/rtHz Chopper-Stabilized Instrumentation Amplifier for Chronic Measurement of Neural Field PotentialsIEEE Journal of Solid-State Circuits, 2007
- A Micropower Chopper-Stabilized Operational Amplifier Using a SC Notch Filter With Synchronous Integration Inside the Continuous-Time Signal PathIEEE Journal of Solid-State Circuits, 2006