Influence of profile geometry on the self-starting capability of an H-Darrieus turbine
Open Access
- 5 May 2025
- journal article
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 14 (4) , 694-702
Abstract
To spread the use of Wind H-Darrieus turbines to electricity generation in urban or rural environments is necessary to improve some of its main drawbacks such as: aerodynamic efficiency, self-starting capability and torque fluctuations. The aims of this study are to enhance the aerodynamic efficiency and self-starting capability of an H-Darrieus turbine through wind tunnel tests combined using a 3D numerical study using Computational Fluid Dynamics (CFD). The NREL S815 profile and four modified versions were evaluated, including one with a 19.2% increase in thickness and three chord-to-diameter ratios: 𝐶/𝐷=0.15, 0.20, and 0.225. These configurations were tested at wind speeds of 6 and 8 m/s. Static torque was measured experimentally, alongside numerical calculations of flow and pressure distribution. A significant correlation between chord length and turbine performance was observed. The 𝐶/𝐷=0.20 profile exhibited increases of up to 50.27% and 58.88% in static torque at 6 and 8 m/s, respectively. The static torque coefficient increased from 0.0063 in the original profile to 0.0447 in the C/D=0.20 profile, directly contributing to the improvement of self-starting capability. Although the 𝐶/𝐷=0.20 geometry showed improvements, the C/D=0.225 profile did not show additional performance gains, indicating that further increases in chord length do not improve turbine performance. The profile modified with a 19.2% increase in thickness ranked just below the 𝐶/𝐷=0.2 profile, exhibiting torque increases of 41% and 25.22% at 6 and 8 m/s, respectively. These findings confirm that chord-to-diameter ratio adjustments play a critical role in boosting torque generation in vertical-axis wind turbines.Keywords
This publication has 40 references indexed in Scilit:
- Performance characterization of a slotted wind turbine airfoil featuring passive blowingEnergy Reports, 2023
- Onshore and offshore wind power generation forecasting using a novel flexible time-varying fractional nonlinear grey modelEnergy Conversion and Management, 2023
- Aerodynamic performance enhancement of the DU99W405 airfoil for horizontal axis wind turbines using slotted airfoil configurationEnergy, 2022
- Effect of upstream deflector utilization on H-Darrieus wind turbine performance: An optimization studyAlexandria Engineering Journal, 2022
- Transient analysis of H-type Vertical Axis Wind Turbines using CFDEnergy Reports, 2022
- A comprehensive three-dimensional study on Darrieus vertical axis wind turbine with slotted blade to reduce flow separationEnergy, 2022
- A framework for preliminary large-scale urban wind energy potential assessment: Roof-mounted wind turbinesEnergy Conversion and Management, 2020
- Blade shape effect on the behavior of the H-rotor Darrieus wind turbine: Performance investigation and force analysisEnergy, 2019
- Experimental and simulation investigation into the effects of a flat plate deflector on vertical axis wind turbineEnergy Conversion and Management, 2018
- Aerodynamic performance enhancements of H-rotor Darrieus wind turbineEnergy, 2018