Development and Characterization of Novel Corrosion‐Resistant TWIP Steels
- 22 December 2010
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 82 (1) , 26-31
Abstract
Austenitic steels exhibiting twinning induced plasticity (TWIP) are materials with exceptional mechanical properties. In this work, the development of new grades of TWIP steels exhibiting corrosion resistance is presented. The alloy development was supported by thermodynamic and diffusion calculations within the (FeMnCr)‐(CN) alloy system. For the calculations ambient pressure and primary austenitic solidification were considered as necessary to avoid nitrogen degassing in all processing steps. Manganese is used as an austenite stabilizer, chromium to increase nitrogen solubility and provide corrosion resistance, while carbon and nitrogen provide mechanical strength. Diffusion calculations were used in order to predict the extent of micro segregations and additionally to evaluate the effect of diffusion annealing treatments. The material was cast in a laboratory scale with a nominal composition of Fe‐20Mn‐12Cr‐0.25C‐0.3N. Diffusion annealing was followed by hot rolling and solution annealing resulting in a fully austenitic microstructure. Tensile tests at room temperature were performed, exhibiting yield strengths of 430 MPa and elongation to fracture of 93%. In addition, not only the mechanical properties but also the weldability was studied, focussing on the characterization of the microstructure of bead on plate welds obtained by laser and TIG welding.Keywords
This publication has 9 references indexed in Scilit:
- Effect of Carbon on Stainless Austenitic CrMnCN Steel CastingsSteel Research International, 2010
- Microstructure and mechanical properties of laser welded austenitic high manganese steelsScience and Technology of Welding and Joining, 2009
- Analysis of the tensile behavior of a TWIP steel based on the texture and microstructure evolutionsMaterials Science and Engineering: A, 2009
- Estimation of Segregation in Iron‐Manganese SteelsAdvanced Engineering Materials, 2007
- Stainless Austenitic CrMnCN Steels of Superior Strength Part I: Alloy Design and PropertiesMaterials Science Forum, 2007
- Effects of alloying elements on martensitic transformation behavior and damping capacity in Fe–17Mn alloyMaterials Science and Engineering: A, 2004
- Supra-Ductile and High-Strength Manganese-TRIP/TWIP Steels for High Energy Absorption Purposes.ISIJ International, 2003
- High strength Fe–Mn–(Al, Si) TRIP/TWIP steels development — properties — applicationInternational Journal of Plasticity, 2000
- Effects of deformation induced phase transformation and twinning on the mechanical properties of austenitic Fe-Mn-Al alloys.ISIJ International, 1989