Assessment of processibility and properties of raw post-consumer waste polyethylene in the rotational moulding process
Authors:
Open Access
- 7 February 2022
- journal article
- research article
- Published by Walter de Gruyter GmbH in Journal of Polymer Engineering
- Vol. 42 (4) , 374-383
Abstract
This paper presents work from an ongoing study into the use of post-consumer waste polymer in the rotational moulding process. Raw plastic recyclate, predominantly consisting of polyethylene, was processed into polymer powders containing an additive package suitable for rotational moulding, with and without the addition of a compatibiliser. Rheological studies on the materials showed very high viscosities at low shear rates in comparison with materials typically used in rotational moulding, which has significant implications for melt flow and bubble removal during the process. It was possible to mould the materials successfully, but poor surface finishes were achieved. Impact strength was drastically lower for recyclate mouldings compared with virgin material. Tensile strength of the recyclate mouldings was reduced compared to virgin polyethylene, but results indicated that optimising the processing conditions could lead to improvements. This work gives some baseline indicators to inform further planned work on optimising processing conditions and identifying viable material compositions.Keywords
This publication has 20 references indexed in Scilit:
- Plastics recycling: challenges and opportunitiesPhilosophical Transactions of the Royal Society B: Biological Sciences, 2009
- Experimental study on the flow and deposition of powder particles in rotational moldingPolymer Engineering & Science, 2004
- Bubble removal in rotational moldingPolymer Engineering & Science, 2004
- Optimization of the rotational moulding process for polyolefinsProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2003
- Bubble dissolution in molten polymers and its role in rotational moldingPolymer Engineering & Science, 1999
- Removal of Pinholes and Bubbles from Rotationally Moulded ProductsProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 1996
- The effect of colorants on the properties of rotomolded polyethylene partsPolymer Engineering & Science, 1996
- The effect of processing variables on the formation and removal of bubbles in rotationally molded productsPolymer Engineering & Science, 1996
- Structure-properties relationships in rotationally moulded polyethyleneJournal of Materials Science, 1996
- Characterization of rotational molding grade polyethylene powdersAdvances in Polymer Technology, 1989