Formulation of Shrinkage Rate of Sinter during Softening Process
Authors:
- 15 July 2020
- journal article
- research article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 60 (7) , 1487-1494
Abstract
In order to clear shrinkage behavior of sinter during softening process, the effects of load and reducing gas condition on the shrinkage rate of sinter packed bed has been investigated using an experimental apparatus for measuring high temperature properties under load. As a result, the shrinkage rate increased with increasing the load impressed to the packed bed in temperature range from 1270 to 1440 K, and decreased with increasing the reduction degree of sinter in temperature range from 1470 to 1570 K. The results indicate that the mechanism of shrinkage was different depending on temperature.In this study, the shrinkage rate of sinter was formulated by dividing into two temperature regions. In the region I, the shrinkage rate increased in proportional to the impressed load, and increased in inversely proportional to the apparent softening viscosity. In the region II, the shrinkage rate increased in proportion to the generation rate of melt, and decreased with increasing the volume fraction of metallic iron in the packed bed. The shrinkage in region II was suppressed with increasing the reduction degree of sinter since the generation rate of melt decreased and the volume fraction of metallic iron increased. The shrinkage rate of each region was expressed as functions of initial composition of sinter, load, temperature, and reduction degree. The calculated values were in good agreement with the experimental ones.Keywords
This publication has 15 references indexed in Scilit:
- FactSage thermochemical software and databases, 2010–2016Calphad, 2016
- Quantitative Estimation of Gas Permeability of Softening Sinter Layer with Liquid PhaseTetsu-to-Hagane, 2014
- Effect of Coke Reactivity on Sinter Softening-Melting Property by Simultaneous Evaluation Method of Carbonaceous and Ferrous Burdens in Blast FurnaceTetsu-to-Hagane, 2012
- Evaluation of Softening, Shrinking and Melting Reduction Behavior of Raw Materials for Blast FurnaceISIJ International, 2011
- Development of Evaluation Method for Softening-melting Properties of SinterTetsu-to-Hagane, 1997
- Reduction Behavior in Cohesive Layer of Blast FurnaceTetsu-to-Hagane, 1987
- Application of High Temperature Properties Test Results to Blast Furnace Operation Analysis and Quality Design of SinterTetsu-to-Hagane, 1986
- Fundamental Study on the Softening Properties of Sinter by Measuring the Apparent Softening ViscosityTetsu-to-Hagane, 1982
- The Shrinkage of Burden Materials and Pressure Drop of Gas in Softening and Fusing Zones of Blast FurnaceTetsu-to-Hagane, 1975
- Measurement of Apparent Viscosity of Variousi Blast Furnace Burdens at Softening TemperatureTetsu-to-Hagane, 1970