Fatigue crack growth in polyethylene
Authors:
- 1 April 1985
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 25 (6) , 313-317
Abstract
Fatigue crack propagation (FCP) rates are studied in 6 mm thick specimens of high density polyethylene (HDPE) containing razor notches, Centrally‐notched plates and single‐edg notched bars are subjected to sinusoidal tension‐compressio or tension‐zero cycling at 0.5 or 2.0 Hz under load control a room temperature; crack growth is monitored using a travelling microscope. After many thousands of cycles with no observable damage at the tip of the razor notch, a craze like zone begins to form. This zone grows slowly until it reaches the length characteristic of a mature crack at the same ΔK. Crack growth proper then begins. The number of cycles to initiate crack growth falls linearly with increasing ΔK at the razor notch Subsequent crack growth is determined both by the current value of ΔK and by loading history. When ΔK is increasing, FCP rates follow a standard Paris law curve. However, reduced, FCP rates are observed following an overload.Keywords
This publication has 9 references indexed in Scilit:
- Fatigue fracture of polycarbonatePolymer Engineering & Science, 1982
- A model of fatigue crack growth in polymersJournal of Materials Science, 1977
- Fatigue crack retardation in polycarbonateJournal of Applied Polymer Science, 1977
- Frequency sensitivity of fatigue processes in polymeric solidsPolymer Engineering & Science, 1975
- Fatigue crack retardation and closure in polymethylmethacrylateEngineering Fracture Mechanics, 1974
- Fatigue-crack growth in polymethylmethacrylateExperimental Mechanics, 1971
- Fatigue Crack Propagation in Polymethylmethacrylate; the Effect of the Mean Value of Stress Intensity FactorJournal of Mechanical Engineering Science, 1971
- Fatigue crack closure under cyclic tensionEngineering Fracture Mechanics, 1970
- Fatigue crack propagation in polymeric materialsJournal of Materials Science, 1970