Enhancement of Saturation Boiling of PF-5060 on Microporous Copper Dendrite Surfaces
- 28 April 2010
- journal article
- Published by Wiley in Journal of Heat Transfer
- Vol. 132 (7) , 071501
Abstract
Experiments are performed to investigate saturation boiling of degassed PF-5060 dielectric liquid on microporous copper dendrite surface layers deposited on 10×10 mm2 Cu substrates. The electrochemically deposited surface layers are of different thicknesses (145.6 μm, 46.3 μm, and 33.1 μm). The thickest layer gives the best results: the saturation CHF of 25.27 W/cm2 occurs at a surface superheat of only 2.9 K and the maximum nucleate boiling heat transfer coefficient, hMNB, near the end of the fully developed nucleate boiling region, is 8.76 W/cm2 K. In addition, nucleate boiling ensues at a surface temperature slightly above saturation (<0.5 K), with no temperature excursion. The temperature excursions before initiating boiling on the 46.3 μm and 33.1 μm thick Cu nanodendrite surface layers are small (3.7 K and 6 K), corresponding to surface temperatures of ∼55.1°C and 57.4°C, respectively. These temperatures are much lower than recommended (85°C) for reliable operation of most silicon electronics and central processor units.Keywords
This publication has 21 references indexed in Scilit:
- Nucleate boiling of FC-72 and HFE-7100 on porous graphite at different orientations and liquid subcoolingEnergy Conversion and Management, 2008
- Pool boiling heat transfer on horizontal rectangular fin array in saturated FC-72International Journal of Heat and Mass Transfer, 2007
- Enhancement of pool boiling critical heat flux in dielectric liquids by microporous coatingsInternational Journal of Heat and Mass Transfer, 2007
- Effect of surface condition on boiling heat transfer from silicon chip with submicron-scale roughnessInternational Journal of Heat and Mass Transfer, 2006
- Enhanced saturation and subcooled boiling of FC-72 dielectric liquidInternational Journal of Heat and Mass Transfer, 2005
- Copper Foam Structures with Highly Porous Nanostructured WallsChemistry of Materials, 2004
- Effects of fin geometry on boiling heat transfer from silicon chips with micro-pin-fins immersed in FC-72International Journal of Heat and Mass Transfer, 2003
- Saturation boiling of HFE-7100 from a copper surface, simulating a microelectronic chipInternational Journal of Heat and Mass Transfer, 2003
- Film Boiling Incipience at the Departure From Natural Convection on Flat, Smooth SurfacesJournal of Heat Transfer, 1998
- An investigation into the effects of various platings on the film coefficient during nucleate boiling from horizontal tubesInternational Journal of Heat and Mass Transfer, 1969