Touch Position Detection in Electrical Tomography Tactile Sensors Through Quadratic Classifier
- 30 October 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 19 (2) , 474-483
Abstract
Traditional electrical tomography tactile sensors consider the usage of the system's finite element model. This approach brings disadvantages that jeopardize their applicability aspect and wide use. To address this limitation, the main thrust of this paper is to present a method for touch position identification for an electrical tomography flexible tactile sensor. This is done by using a supervised machine learning algorithm for performing classification, namely quadratic discriminant analysis. This approach provides accurate contact location identification, increasing the detection speed and the sensor versatility when compared with traditional electrical tomography approaches. Results obtained show classification accuracy rates of up to 91.6% on unseen test data and an average Euclidean error ranging from 1 to 10 mm depending on the contact location over the sensor. The sensor is then applied in real case scenarios to show its efficiency. These outcomes are encouraging since they promote the future practical usage of flexible and low-cost sensors.Keywords
This publication has 34 references indexed in Scilit:
- Interpretation of the modality of touch on an artificial arm covered with an EIT-based sensitive skinThe International Journal of Robotics Research, 2012
- Rod‐Coating: Towards Large‐Area Fabrication of Uniform Reduced Graphene Oxide Films for Flexible Touch ScreensAdvanced Materials, 2012
- Addressing the computational cost of large EIT solutionsPhysiological Measurement, 2012
- Highly sensitive flexible pressure sensors with microstructured rubber dielectric layersNature Materials, 2010
- Cross-Validation2009
- Pseudo-polar drive patterns for brain electrical impedance tomographyPhysiological Measurement, 2006
- Automatic detection of detached and erroneous electrodes in electrical impedance tomographyPhysiological Measurement, 2005
- Selection of relevant features and examples in machine learningArtificial Intelligence, 1997
- Assessment of errors in static electrical impedance tomography with adjacent and trigonometric current patternsPhysiological Measurement, 1997
- A neural network image reconstruction technique for electrical impedance tomographyIEEE Transactions on Medical Imaging, 1994