High-Resolution Capacitive Microinclinometer With Oblique Comb Electrodes Using (110) Silicon
Authors:
- 6 October 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 20 (6) , 1269-1276
Abstract
We propose a new capacitive microinclinometer where oblique comb electrodes and double-folded suspension springs are aligned parallel to the vertical (111) plane of (110) silicon. The oblique comb utilizes both the overlapped area and the gap between movable and stationary electrodes, resulting in a considerable increase in sensitivity (capacitance change/angle). The resolution becomes even higher by taking advantage of the smooth (111) sidewalls of the oblique comb electrodes, which are fabricated using silicon deep reactive ion etching followed by crystalline wet etching. The surface roughness was reduced from 200 (Rrms) to 20 nm (Rrms), and the verticality was improved from 88.7° to 89.7°. The capacitance change of the fabricated inclinometer experimentally ranges from -0.793 to 0.783 pF for the full range of inclination angle (from -90° to 90°). The estimated worst resolution, which is obtainable at an inclination angle of ±85°, was as low as 0.25°.Keywords
This publication has 14 references indexed in Scilit:
- Fabrication of morphological defect-free vertical electrodes using a (1 1 0) silicon-on-patterned-insulator process for micromachined capacitive inclinometersJournal of Micromechanics and Microengineering, 2009
- Novel Micro Capacitive Inclinometer with Oblique Comb Electrode and Suspension Spring Aligned Parallel to {111} Vertical Planes of (110) Silicon2009
- An optimized MEMS-based electrolytic tilt sensorSensors and Actuators A: Physical, 2007
- Micro Capacitive Tilt Sensor for Human Body Movement Detection2007
- Etch characteristics of KOH, TMAH and dual doped TMAH for bulk micromachining of siliconMicroelectronics Journal, 2006
- Fabrication of vertical optical plane using DRIE and KOH crystalline etching of (110) silicon waferSensors and Actuators A: Physical, 2006
- A CMOS-compatible high aspect ratio silicon-on-glass in-plane micro-accelerometerJournal of Micromechanics and Microengineering, 2004
- A high-aspect-ratio comb actuator using UV-LIGA surface micromachining and (110) silicon bulk micromachiningJournal of Micromechanics and Microengineering, 2002
- Safety relevant microsystems for automotive applicationsMicrosystem Technologies, 2002
- Mechanical-thermal noise in micromachined acoustic and vibration sensorsIEEE Transactions on Electron Devices, 1993