Single-pass full-penetration welding for thick stainless steel using high-current GMAW
Authors:
- 3 June 2021
- journal article
- research article
- Published by Taylor & Francis in Welding International
- Vol. 35 (4-6) , 240-253
Abstract
This paper describes a high-current Gas Metal Arc Welding (GMAW) process using a constant voltage power source developed for high-efficiency welding of thick stainless steel plates. A short arc length as a welding condition is preferable to concentrate the arc and obtain a deep penetration for thick plate welding. However, it is easily found that an unstable arc derived from a short circuit happens irregularly by using a general purpose GMAW with constant voltage characteristics. A ‘low-frequency modulated voltage control’ was applied for stabilizing a high-current arc that can maintain a short arc length without short circuiting. The welded joint using the developed welding process showed the similar corrosion resistance as that using the submerged arc welding; however, porosity was observed in the welded joints using the developed welding process in the current region of 400 A or above. Consequently, a new current waveform control that changes the welding current dynamically and periodically has been developed, which realized reducing porosity and single-pass full-penetration welding of 9-mm-thickness type 304 stainless steel plates with square groove.Keywords
This publication has 27 references indexed in Scilit:
- Double-Sided Single-Pass Submerged Arc Welding for 2205 Duplex Stainless SteelJournal of Materials Engineering and Performance, 2013
- Submerged arc welding of stainless steel and the challenge from the laser welding processJournal of Materials Processing Technology, 2003
- Study on Gas Metal Arc Welding Procedure of Stainless Steel.QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2000
- Inhibiting effect of low‐frequency pulsed MIG welding on blowhole generation in AI and its alloys (3rd report). Study of low‐frequency pulsed MIG weldingWelding International, 1994
- Study on Low Freguency Pulsed MIG Welding Process(Report 3). The Inhibitative Effect of Low Freguency Pulsed MIG Welding Process on Blowhole Generation for Al and Its Alloy.QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 1994
- Study of low‐frequency pulsed MIG weldingWelding International, 1993
- Beneficial effects of low‐frequency pulsed MIG welding on grain refinement of weld metal and improvement of solidification crack susceptibility of aluminium alloys: Study of low‐frequency pulsed MIG weldingWelding International, 1993
- Development of Low Frequency Pulsed MIG Welding Process for Al and its alloy. Study on Low Frequency Pulsed MIG Welding Process. (Report 1).QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 1992
- The Beneficial Effect of Low Frequency Pulsed MIG Welding Process on Grain Refinement of Weld Metal and Improvement of Solidification Crack Susceptibility for Al Alloy. Study on Low Frequency Pulsed MIG Welding Process. Report 2.QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 1992
- Simultaneous control of penetration depth and bead height by controlling multiple welding parameters.QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 1989