Effects of pulse reverse electroforming parameters on the thickness uniformity of electroformed copper foil
Authors:
- 27 February 2018
- journal article
- research article
- Published by Taylor & Francis in Transactions of the IMF
- Vol. 96 (2) , 108-112
Abstract
The non-uniformity of electroformed layers directly affects the mechanical properties and application requirements of micro devices. Therefore, uniformity of electroformed copper foil is significant in ensuring or improving the mechanical properties of micro devices. The influences of duty cycle, current density, power source, and electroforming time on the thickness uniformity of electroformed copper layers were studied, and these parameters were optimised by using the orthogonal experiment method. The thickness distribution rule of electroformed copper foil was also determined. Duty cycle had the largest influence on the uniformity; the uniformity of electroformed layers prepared with pulse reverse current power source was superior to those prepared with direct current power source and pulse current power source. Increasing current density enhanced uniformity. The optimal technical process suggested by this orthogonal experiment adopts pulse reverse current power, 30% of positive duty cycle, 10% of negative duty cycle, 2 A dm−2 of current density, and 92 minutes of electroforming time. The minimum coefficient of variation reached 1.54%. The thickness of electroformed copper foil varied directionally.Keywords
Funding Information
- National Natural Science Foundation of China (51675283)
- Jiangsu Natural Science Foundation (BK20151489)
- Shanghai Aerospace Science and Technology Innovation Foundation (2015044)
This publication has 15 references indexed in Scilit:
- Study on Improving Thickness Uniformity of Microfluidic Chip Mold in the Electroforming ProcessMicromachines, 2016
- Size effects on tensile strength of aluminum–bronze alloy at room temperatureMaterials & Design, 2015
- Modeling and Experimental Validation of Electroplating Deposit Distributions from Copper Sulfate SolutionsECS Transactions, 2014
- Influence of Process Parameters on Pulse Electroforming of Nickel-Rich Nickel-Cobalt Alloys from Sulfamate ElectrolyteAdvanced Materials Research, 2013
- Effects of Additives on Cu-MWCNT Composite Plating FilmsJournal of the Electrochemical Society, 2010
- Uniformity study of nickel thin-film microstructure deposited by electroplatingMicrosystem Technologies, 2009
- Pulse reverse plating for uniform nickel height in zone platesJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2006
- Uniformity Control of Ni Thin-Film Microstructures Deposited by Through-Mask PlatingJournal of the Electrochemical Society, 2005
- Optimization of Thickness Uniformity in Electrodeposition onto a Patterned SubstrateMATERIALS TRANSACTIONS, 2004
- Understanding and improving the uniformity of electrodepositionSurface and Coatings Technology, 2003