Teat Sinus Vacua at Different Milking Machine Vacua and Pulsator Ratios
Authors:
Open Access
- 1 August 1967
- journal article
- Published by American Dairy Science Association in Journal of Dairy Science
- Vol. 50 (8) , 1237-1240
Abstract
Nine quarters of three cows were used in measuring maximum and residual teat sinus vacua after the end of milk flow at four milking vacuum levels and two pulsator ratios. The increase in maximum and residual teat sinus vacua was nearly linear from 250 to 400 Into Jig milking vacuum. Between 400 and 500 mm Hg milking vacuum, the increase in maximum teat sinus vacuum was noulinear and increased rapidly. Congestion of the teat end and signs of discomfort to the cow were observed when the milking vacuum was 500 mm Jig. From results of this study, it would appear that a stable milking vacuum above 400 mm Itg should be avoided, because of excessive teat sinus vacuum and possible teat injury.Keywords
This publication has 7 references indexed in Scilit:
- Bovine Intramammary Pressure Changes during Mechanical MilkingJournal of Dairy Science, 1964
- Effects of Vacuum Level and Milking Duration on Guernseys and Holsteins Differing with Respect to Lactation Number and Status of Udder Health. I. Udder HealthJournal of Dairy Science, 1955
- Effects of Vacuum Level and Milking Duration on Milk Production, Milking Time and Rate of Milk Flow in Mastitis-Free First Calf HeifersJournal of Dairy Science, 1954
- A Further Study of Effects of Vacuum Level and Milking Duration on Udder Health and Milk ProductionJournal of Dairy Science, 1953
- Effects of Vacuum Level and Milking Duration on Udder Health in Mastitis-free First Calf HeifersJournal of Dairy Science, 1953
- The Effect of Increasing the Negative Pressure and Widening of the Vacuum-Release Ratio on the Rate of Removal of Milk from the UdderJournal of Dairy Science, 1946
- The Action of the Mechanical Milker in Relation to Completeness of Milking and Udder InjuryJournal of Dairy Science, 1944