Macromolecular modification of EPDM: Wettability, miscibility, and morphology study
- 5 April 2001
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 80 (14) , 2647-2661
Abstract
The present investigation deals with studies on wettability, miscibility, and morphology of the macromolecularly modified EPDM. Two different maleated EPDM rubbers (grafted rubber) were chosen (0.5 and 1% maleation) for such modification and they were used in various proportions. Wettability of the rubber substrate, as observed from dynamic contact angle measurement, was improved using these grafted rubbers. Results of X‐ray photoelectron spectroscopy showed an increase in oxygen level with higher levels of grafted rubber in the blends. Morphology study by transmission electron microscopy showed a smaller domain size for the blend with higher maleic anhydride content in the grafted rubber. The viscosity versus blend ratio results showed a negative deviation behavior for blends with 1% grafted rubber, whereas a positive negative deviation behavior was observed in blends with 0.5% grafted EPDM. As the strength of interaction increased, the glass transition shifted to a higher temperature. All blends were heterogeneous, as indicated by different degrees of dispersion. © 2001 John Wiley & Sons, Inc. J Appl Polym Sci 80: 2647–2661, 2001Keywords
This publication has 32 references indexed in Scilit:
- Rheological properties of ethylene–propylene block copolymer and EPDM rubber blends using a torque rheometerEuropean Polymer Journal, 1999
- Effect of addition of polyoxypropylenediamine on the morphology and mechanical properties of maleated polypropylene/maleated rubber blendsJournal of Applied Polymer Science, 1998
- Rheology and properties of EPDM/BR blends with or without a homogenizing agent or a coupling agentJournal of Applied Polymer Science, 1996
- Radiation graft modification of ethylene-propylene rubber—III. Effect on water uptake, wettability and biocompatibilityRadiation Physics and Chemistry, 1996
- CO2-laser graft copolymerization of HEMA and NVP onto ethylene-propylene rubber (EPR) as biomaterial-(III)Radiation Physics and Chemistry, 1995
- The improvement in adhesion of polyurethane-polypropylene composites by short-time exposure of polypropylene to low and atmospheric pressure plasmasJournal of Adhesion Science and Technology, 1995
- Studies of in-situ Compatibilized Blend of Silicone and EPDM RubbersRubber Chemistry and Technology, 1994
- Blends of Dissimilar Rubbers—Cure-Rate IncompatibilityRubber Chemistry and Technology, 1988
- Adhesion between individual components and mechanical properties of natural rubber-polypropylene thermoplastic elastomeric blendsJournal of Adhesion Science and Technology, 1988
- Heterogeneous Blends of Polymers. Rheology and MorphologyRubber Chemistry and Technology, 1976