Quantitative investigation of the O 2 + ‐induced topography of GaAs and other III–V semiconductors: An STM study of the ripple formation and suppression of the secondary ion yield change by sample rotation
Authors:
- 1 July 1995
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 23 (7-8) , 506-513
Abstract
Roughening procedures including the early stage of the O 2 + ‐induced ripple formation of GaAs were studied quantitatively by scanning tunnelling microscopy (STM). Detailed examinations of the beginning of topography development using fast Fourier transform of the STM images revealed that the ripple formation was not caused by any accidental defects, particles or original irregularity on the substrate, but solely by the conditions of the ion beam. A systematic investigation of the rippled GaAs surface produced under various O 2 + bombardment conditions was conducted. The ripple wavelength and the transition depth were almost exactly proportional to E P cos θ, where E P and θ are the energy of the ion beam and the incident angle, respectively. For GaAs, the secondary ion yield transition occurs when the slope of ripples facing the incident O 2 + beam reaches a saturation angle of 20–30° from the macroscopic surface plane. Topography change on other III–V semiconductors was also examined for comparison. There was no ripple generation observed for GaP; InP gave a ripple‐like structure without secondary ion yield change. A relatively rough surface resulted on GaSb and InAs at a much shallower depth than for GaAs. Rippling and ion yield changes during depth profiling have been suppressed successfully by sample rotation even in a magnetic sector‐based instrument.Keywords
This publication has 20 references indexed in Scilit:
- Influence of oxygen on the formation of ripples on SiJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1993
- A study of the secondary-ion yield change on the GaAs surface caused by the O+2 ion-beam-induced ripplingJournal of Vacuum Science & Technology A, 1991
- Effect of surface roughening on secondary ion yields and erosion rates of silicon subject to oblique oxygen bombardmentJournal of Vacuum Science & Technology A, 1990
- Secondary ion yield changes in Si and GaAs due to topography changes during O+2 or Cs+ ion bombardmentJournal of Vacuum Science & Technology A, 1988
- Surface morphology of Si(100), GaAs(100) and InP(100) following O2+ and Cs+ ion bombardmentVacuum, 1984
- The mechanisms of etch pit and ripple structure formation on ion bombarded Si and other amorphous solidsNuclear Instruments and Methods, 1980
- Depth resolution in sputter profilingApplied Physics A, 1977
- Ion bombardment induced ripple topography on amorphous solidsRadiation Effects, 1977
- The topography of sputtered semiconductorsRadiation Effects, 1973
- Surface damage and topography changes produced during sputteringRadiation Effects, 1973