Experimental study on the chip morphology, tool–chip contact length, workpiece vibration, and surface roughness during high-speed face milling of A6061 aluminum alloy
- 15 July 2019
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 234 (3) , 610-620
Abstract
In this study, experiments of high-speed face milling of A6061 aluminum alloy with a carbide insert milling cutter under dry cutting conditions were conducted. The contact length between tool and chip, the workpiece vibration amplitude, and the arithmetic average surface roughness were measured under varying cutting conditions (cutting speed, feed rate, and depth of cut). The characteristics of chip morphology were observed using scanning electron microscope. Experimental results showed that the increasing cutting speed reduced the tool–chip contact length, the workpiece vibration, and the surface roughness. The tool–chip contact length, the workpiece vibration, and the surface roughness were all increased with increasing cutting depth and feed rate. The results of chip morphology showed that the chips with serrated form were generated under high-speed cutting conditions. Moreover, scratch lines, plastic deformation cavities, and local molten chip material were observed on the slide chip surface.Keywords
This publication has 33 references indexed in Scilit:
- On the SPH Orthogonal Cutting Simulation of A2024-T351 AlloyProcedia CIRP, 2013
- Quantification of the chip segmentation in metal machining: Application to machining the aeronautical aluminium alloy AA2024-T351 with cemented carbide tools WC-CoInternational Journal of Machine Tools and Manufacture, 2013
- Analysis of a new Segmentation Intensity Ratio “SIR” to characterize the chip segmentation process in machining ductile metalsInternational Journal of Machine Tools and Manufacture, 2011
- Fatigue crack growth behaviour and life prediction for 2324-T39 and 7050-T7451 aluminium alloys under truncated load spectraInternational Journal of Fatigue, 2010
- Numerical and experimental study of dry cutting for an aeronautic aluminium alloy (A2024-T351)International Journal of Machine Tools and Manufacture, 2008
- The influence of feed rate and cutting speed on the cutting forces, surface roughness and tool–chip contact length during face millingMaterials & Design (1980-2015), 2007
- An Experimental Study of Cutting Forces in High-Speed End Milling and Implications for Dynamic Force ModelingJournal of Manufacturing Science and Engineering, 2005
- Multiple chatter frequencies in milling processesJournal of Sound and Vibration, 2003
- Recent development in aluminium alloys for aerospace applicationsMaterials Science and Engineering: A, 2000
- Analytical Prediction of Stability Lobes in MillingCIRP Annals, 1995