Comparative research on the effect of an oxide coating and a tribo-oxide layer on dry sliding wear of Ti–6Al–4V alloy
- 16 February 2018
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 232 (12) , 1569-1580
Abstract
The effect of an oxide coating and a tribo-oxide layer on dry sliding wear of Ti–6Al–4V alloy was comparatively studied. The oxide coating was prepared on Ti–6Al–4V alloy by a thermal oxidation/diffusion process; the tribo-layer was an in situ produced mechanically mixed layer during dry sliding. The oxide coating markedly improved the wear performance of Ti–6Al–4V alloy at room and elevated temperatures. Tribo-layers were classified into three types: no-oxide tribo-layer, porous, and dense tribo-oxide layers. Both porous and dense tribo-oxide layer presented protective function, thus significantly improving wear performance of Ti–6Al–4V alloy. However, no other than dense tribo-oxide layer was qualified to be comparable to the oxide coating, which almost possessed the same wear-reduced function as the oxide coating. Even when the oxide coating was severely delaminated, the tribo-oxide layer would replace the oxide coating and took effect to protect from wear.Keywords
This publication has 25 references indexed in Scilit:
- Wear Characteristics of Ti-6Al-4V Alloy at 20–400°CTribology Transactions, 2012
- Influence of microstructure on tribologically mixed layersWear, 2011
- Experimental study on turning of TC9 titanium alloy with cold water mist jet coolingInternational Journal of Machine Tools and Manufacture, 2011
- A comparative study of mechanically mixed layers (MMLs) characteristics of commercial aluminium alloys sliding against alumina and steel slidersJournal of Materials Processing Technology, 2008
- Microstructure and tribological characteristics of Ti–6Al–4V alloy against GCr15 under high speed and dry slidingMaterials Science and Engineering: A, 2006
- Improvement of wear resistance of Ti–6Al–4V alloy by means of thermal oxidationMaterials Letters, 2005
- Oxygen boost diffusion for the deep-case hardening of titanium alloysMaterials Science and Engineering: A, 2000
- Dry sliding wear of Ti–6Al–4V alloy as influenced by the counterface and sliding conditionsWear, 1999
- Effects of load and sliding speed on the tribological behaviour of Ti6Al4V plasma nitrided different temperaturesWear, 1997
- The third-body approach: A mechanical view of wearWear, 1984