Dynamic frequency-switching clock system on a quad-core Itanium® processor
Authors:
- 1 February 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01936530,p. 62-63,63a
Abstract
The700mm 2 65nm Itanium reg processor codenamed Tukwila integrates four cores and a system interface with six QuickPath reg interconnect channels and four memory interconnect channels. The large die and high level of integration coupled with process variability present clock-system design challenges in the areas of power consumption and variability compensation that discuss in this paper. The clock system, which is a cascaded-PLL architecture with an initial filter PLL that receives a 133 MHz reference clock. This maiden PLL filters reference-clock jitter and outputs a 133 MHz clock to 13 downstream PLLs. Each downstream PLL has a duty-cycle corrector that monitors and corrects the end-of-route duty cycle.Keywords
This publication has 5 references indexed in Scilit:
- A 65nm 2-Billion-Transistor Quad-Core Itanium® Processor2008
- Power and Temperature Control on a 90-nm Itanium Family ProcessorIEEE Journal of Solid-State Circuits, 2005
- Clock distribution on a dual-core, multi-threaded Itanium-family processor2005
- Self-biased high-bandwidth low-jitter 1-to-4096 multiplier clock generator PLLIEEE Journal of Solid-State Circuits, 2003
- Jitter and phase noise in ring oscillatorsIEEE Journal of Solid-State Circuits, 1999