An Experimental Study of the Water-Assisted Injection Molding of PA-6 Composites
Authors:
- 31 January 2008
- journal article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 27 (9) , 985-999
Abstract
This report was carried out to study experimentally the water-assisted injection molding process of glass fiber-reinforced polyamide-6 (Nylon-6) composites. Experiments were carried out on an 80 ton injection molding machine equipped with a lab scale water injection system, which included a water pump, a water injection pin, a pressure accumulator, a water tank equipped with a temperature regulator, and a control circuit. The materials used were Nylon and 30% glass fiber-filled Nylon composites. A spiral mold cavity was used to mold the composites. After molding, the lengths of water penetration in molded parts were measured. The effects of different processing parameters on the lengths of water penetration were determined: melt temperature, mold temperature, melt-filling speed, short-shot size, water pressure, water temperature, water hold, and water injection delay time. Mechanical property tests were performed on the water-assisted injection molded parts. X-ray diffraction was also employed to identify the structural parameters of the materials. In addition, the in-mold temperature distribution of the polymeric materials during the cooling process was measured. Irregular water penetration in molded parts was observed, and water temperature was found to affect the crystallinity distribution of molded parts. Nevertheless, its effects on the tensile properties of molded materials were relatively limited.Keywords
This publication has 6 references indexed in Scilit:
- Core out geometries in water channels of water assisted injection moulded partsPlastics, Rubber and Composites: Macromolecular Engineering, 2006
- Experimental investigation and numerical simulation of cooling process in water assisted injection moulded partsPlastics, Rubber and Composites: Macromolecular Engineering, 2004
- The manufacturing of thermoplastic composite parts by water-assisted injection-molding technologyComposites Part A: Applied Science and Manufacturing, 2004
- Effect of melt temperature and skin‐core morphology on the mechanical performance of nylon 6Polymer Engineering & Science, 2002
- Gas assisted injection moulding: Finite element modelling and experimental validationPlastics, Rubber and Composites: Macromolecular Engineering, 2000
- Development and application of CAE technology for the gas‐assisted injection molding processAdvances in Polymer Technology, 1995