Mitigation of Gas Porosity in Additive Manufacturing Using Experimental Data Analysis and Mechanistic Modeling
Open Access
Abstract
Shielding gas, metal vapors, and gases trapped inside powders during atomization can result in gas porosity, which is known to degrade the fatigue strength and tensile properties of components made by laser powder bed fusion additive manufacturing. Post-processing and trial-and-error adjustment of processing conditions to reduce porosity are time-consuming and expensive. Here, we combined mechanistic modeling and experimental data analysis and proposed an easy-to-use, verifiable, dimensionless gas porosity index to mitigate pore formation. The results from the mechanistic model were rigorously tested against independent experimental data. It was found that the index can accurately predict the occurrence of porosity for commonly used alloys, including stainless steel 316, Ti-6Al-4V, Inconel 718, and AlSi10Mg, with an accuracy of 92%. In addition, experimental data showed that the amount of pores increased at a higher value of the index. Among the four alloys, AlSi10Mg was found to be the most susceptible to gas porosity, for which the value of the gas porosity index can be 5 to 10 times higher than those for the other alloys. Based on the results, a gas porosity map was constructed that can be used in practice for selecting appropriate sets of process variables to mitigate gas porosity without the need for empirical testing.Keywords
This publication has 70 references indexed in Scilit:
- A deep learning framework for defect prediction based on thermographic in-situ monitoring in laser powder bed fusionJournal of Intelligent Manufacturing, 2023
- A deep learning framework for layer-wise porosity prediction in metal powder bed fusion using thermal signaturesJournal of Intelligent Manufacturing, 2022
- Hot isostatic pressing of laser powder bed fusion AlSi10Mg: parameter identification and mechanical propertiesJournal of Materials Science, 2022
- Probabilistic predictive control of porosity in laser powder bed fusionJournal of Intelligent Manufacturing, 2021
- Development of an empirical process model for adjusted porosity in laser-based powder bed fusion of Ti-6Al-4VThe International Journal of Advanced Manufacturing Technology, 2021
- Effect of Hot Isostatic Pressing and Powder Feedstock on Porosity, Microstructure, and Mechanical Properties of Selective Laser Melted AlSi10MgMetallography, Microstructure, and Analysis, 2018
- Synchrotron-Based X-ray Microtomography Characterization of the Effect of Processing Variables on Porosity Formation in Laser Power-Bed Additive Manufacturing of Ti-6Al-4VJOM, 2017
- Normalised model-based processing diagrams for additive layer manufacture of engineering alloysActa Materialia, 2016
- Failure of metals II: FatigueActa Materialia, 2016
- Rapid Solidification: Selective Laser Melting of AlSi10MgJOM, 2016