An Improved Phase-Robust Configuration for Vibration Amplitude-Phase Extraction for Capacitive MEMS Gyroscopes
Open Access
- 22 July 2018
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 9 (7) , 362
Abstract
This paper presents for the first time an improved algorithm for vibration amplitude-phase information extraction of capacitive microelectromechanical systems (MEMS) gyroscopes. Amplitude and phase information resulting from the improved algorithm is insensitive to the phase variation of an interface capacitance-voltage (CV) circuit, thus both long time drift of the gyroscope and bias instability have been improved. Experimental results show that both the phase and amplitude information extracted using this improved algorithm is insensitive to phase variation of CV circuit which is in accordance with theory. Bias instability using this improved configuration is 0.64°/h, which is improved two times more than the configuration using traditional double-side-band (DSB) demodulation configuration, and 4.3 times more than the configuration using single-side-band (SSB) demodulation, respectively. Allan deviation analysis shows that the slow varying drift term using D&S configuration is effectively reduced due to its robustness to CV phase variation compared to test results using DSB or SSB configuration.Keywords
Funding Information
- China National Funds for Distinguished Young Scientists (61525403)
- Fundamental Research Funds for the Central Universities (2017QN81007)
This publication has 9 references indexed in Scilit:
- Low-noise, low-offset modulator demodulator circuit for chopper stabilization technique in CMOS-MEMS sensor applications2014
- Design of a digital closed control loop for the sense mode of a mode-matching MEMS vibratory gyroscope2014
- A 5-V 290- $\mu\hbox{W}$ Low-Noise Chopper-Stabilized Capacitive-Sensor Readout Circuit in 0.8- $\mu\hbox{m}$ CMOS Using a Correlated-Level-Shifting TechniqueIEEE Transactions on Circuits and Systems II: Express Briefs, 2014
- Constant-frequency oscillation control for vibratory micro-machined gyroscopesSensors and Actuators A: Physical, 2013
- Quadrature-Error Compensation and Corresponding Effects on the Performance of Fully Decoupled MEMS GyroscopesJournal of Microelectromechanical Systems, 2012
- Frequency modulation based angular rate sensor2011
- Process flow improvement on a bulk micromachined gyroscopeMicro & Nano Letters, 2009
- A Closed-Loop Digitally Controlled MEMS Gyroscope With Unconstrained Sigma-Delta Force-FeedbackIEEE Sensors Journal, 2009
- Decoupled microgyros and the design principle DAVEDSensors and Actuators A: Physical, 2002