Survey of architectures and optimizations for wide bandwidth envelope amplifier
- 1 September 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. LS8d.1-1
Abstract
In the last years, RF power amplifiers are taking advantage of the switched dc-dc converters to use them in several architectures that may improve the efficiency of the amplifier, keeping a good linearity. The use of linearization techniques such as Envelope Elimination and Restoration (EER) and Envelope Tracking (ET) requires a very fast dc-dc power converter to provide variable voltage supply to the power amplifier but theoretically the efficiency can be much higher than using the classical amplifiers belonging to classes A, B or AB. The purpose of this paper is to analyze the state of the art of the power converters used as envelope amplifiers in this application where a fast output voltage variation is required. The power topologies will be explored and several important parameters such as efficiency, bandwidth and output voltage range will be discussed.Keywords
This publication has 27 references indexed in Scilit:
- Inductor optimization procedure for Power Supply in Package and Power Supply on Chip2011
- Serial or parallel linear-assisted switching converter as envelope amplifier: Optimization and comparison2011
- Optimum design of an envelope tracking buck converter for RFPA using GaN HEMTs2011
- Multilevel converter for Envelope Tracking in RF power amplifiers2009
- A 50MHz bandwidth multi-mode PA supply modulator for GSM, EDGE and UMTS application2008
- Optimum Bias Calculation for Parallel Hybrid Switching-Linear Regulators2007
- Wide-bandwidth digital multi-phase controller2006
- A digitally controlled DC/DC converter for an RF power amplifierIEEE Transactions on Power Electronics, 2006
- Efficiency Optimization in Linear-Assisted Switching Power Converters for Envelope Tracking in RF Power Amplifiers2005
- Power supply for a radio transmitter with modulated supply voltage2004