Modeling the Thermal Actuation in a Thermo-Pneumatic Micropump
- 1 December 2003
- journal article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 125 (4) , 527-530
Abstract
The analysis of a thermo-pneumatic actuation unit for its use in a micropump has been carried out. Coupled thermo-mechanical simulations by finite element method (FEM) (with ANSYS software) were required because of the complexity of the device. The simulation results were validated by thermal and mechanical experimental results, showing a good agreement. FEM results have been used to extract a high level model of the actuation unit that can be used to estimate the maximum performance of the micropump operation with this actuation unit. In order to identify the best frequency of operation for the pump, a quality parameter has been defined based on the thermal dynamics of the actuation unit.Keywords
This publication has 9 references indexed in Scilit:
- Process-dependent Thermophysical Properties Of CMOS IC Thin Films2005
- A time-domain method for the analysis of thermal impedance response preserving the convolution formIEEE Transactions on Components and Packaging Technologies, 1999
- Design of a modular micropump based on anodic bondingJournal of Micromechanics and Microengineering, 1997
- A valve-less planar pump isotropically etched in siliconJournal of Micromechanics and Microengineering, 1996
- Transient measurements on miniaturized diaphragm pumps in microfluid systemsSensors and Actuators A: Physical, 1995
- Annealing-temperature dependence of the thermal conductivity of LPCVD silicon-dioxide layersIEEE Electron Device Letters, 1993
- A micro membrane pump with electrostatic actuation1992
- A thermopneumatic micropump based on micro-engineering techniquesSensors and Actuators A: Physical, 1990
- A thermo-pneumatic actuation principle for a microminiature pump and other micromechanical devicesSensors and Actuators, 1989