Development of a bus armrest fabrication process with a high-vacuum, high-pressure die-casting process using the AM60 alloy
Authors:
- MyeongHan YooMYMyeongHan Yoo
- JoonHyuk SongJSJoonHyuk Song
- JeHa OhJOJeHa Oh
- ShinJae KangSKShinJae Kang
- KwangSeok KimKKKwangSeok Kim
- SungMo YangSYSungMo Yang
- MinSeok MoonMMMinSeok Moon
- 1 February 2019
- journal article
- research article
- Published by Elsevier in Robotics and Computer-Integrated Manufacturing
- Vol. 55, 154-159
Abstract
No abstract availableFunding Information
- Ministry of Knowledge Economy
- (MKE) (B0009719)
This publication has 6 references indexed in Scilit:
- On the ductility potential and assessment of structural quality in Mg alloy castingsMaterials Science and Engineering: A, 2015
- A study of the corrosive behavior of STS304 and STS 430, depending on surface pre-treatment conditions, in PEMFC while in operationInternational Journal of Precision Engineering and Manufacturing, 2014
- Experimental study on influence of section thickness on mechanical behavior of die-cast AM60 magnesium alloyMaterials & Design (1980-2015), 2012
- Mechanical Properties of 0.25-0.65wt% CaO added AM60B Eco-Mg Diecastings at room and Elevated TemperaturesJournal of the Korea Foundry Society, 2011
- Investigating deformation processes in AM60 magnesium alloy using the acoustic emission techniqueActa Materialia, 2006
- Improving the strength and ductility of magnesium die-casting alloys via rare-earth additionJOM, 2003