Full-waveform centroid moment tensor inversion of passive seismic data acquired at the reservoir scale
- 13 April 2022
- journal article
- research article
- Published by Oxford University Press (OUP) in Geophysical Journal International
- Vol. 230 (3) , 1725-1750
Abstract
Passive seismic inversion at the reservoir scale offers the advantages of low cost, negligible environmental impact, and the ability to probe a target area with low-frequency energy not afforded by even the most modern active-source seismic technology. In order to build starting models suitable for full-waveform wavespeed tomography, characterization of earthquake sources is an indispensable first step. We present a workflow for the centroid moment tensor (CMT) inversion of seismic events identified in a passive seismic data set acquired by a large and dense array of three-component broadband seismic sensors in a mountainous setting in the Himalayan foothills. The dataset comprised 256 instruments operating for 2×4 months over an area of 8,000 km2. An initial three-dimensional (3-D) wavespeed model was determined for the region via the analysis of first-arriving traveltime picks. Of the 2,607 identified seismic events that were well recorded at frequencies between 0.2–50 Hz, 86 with magnitudes 1.3 ≤ M ≤ 3.0 initially had their CMT focal mechanisms determined by a waveform fitting procedure built on a Green’s function approach in a one-dimensional (1-D) layered average wavespeed model, for stations within an offset of 10 km, in the frequency range 0.2–1.4 Hz. Here, we obtain updated CMT mechanisms for the 86 events in that catalog via multicomponent full-waveform inversion in the 3-D wavespeed model. Our workflow includes automated data- and model-driven data selection using a combination of different metrics derived from signal-to-noise considerations and waveform-fitting criteria, and relies upon spectral-element simulations of elastic wave propagation in the 3-D wavespeed model, honoring topography. Starting from the initial CMT solutions, we seek improvement to the data fit within the frequency band 0.5–2.5 Hz by minimizing the waveform difference between observed and synthetic data, while accommodating wavespeed-model errors by allowing for small time-shifts. We balance uneven data coverage and tune their contributions via data-space weighting functions. We quantify the improvements to the data fit in terms of different metrics. We summarize the changes to the CMT solutions, and present and analyze the resulting catalog for the region, including their breakdown into double-couple and non-double couple components, and their relation to mapped faults in the region.Keywords
This publication has 55 references indexed in Scilit:
- Seismic imaging: From classical to adjoint tomographyTectonophysics, 2012
- ObsPy: A Python Toolbox for SeismologySeismological Research Letters, 2010
- Adjoint Tomography of the Southern California CrustScience, 2009
- Inversion of moment tensor focal mechanisms for active stresses around the microcontinent Iberia: Tectonic implicationsTectonics, 2008
- Influence of Focal Mechanism in Probabilistic Seismic Hazard AnalysisBulletin of the Seismological Society of America, 2004
- Spectral-Element Moment Tensor Inversions for Earthquakes in Southern CaliforniaBulletin of the Seismological Society of America, 2004
- Ambient Noise Levels in the Continental United StatesBulletin of the Seismological Society of America, 2004
- Simulations of Ground Motion in the Los Angeles Basin Based upon the Spectral-Element MethodBulletin of the Seismological Society of America, 2004
- PAI-S/K: A robust automatic seismic P phase arrival identification schemeIEEE Transactions on Geoscience and Remote Sensing, 2002
- Bootstrap Methods: Another Look at the JackknifeThe Annals of Statistics, 1979