High performance Dyneema® fiber laminate for impact resistance/macro structural composites
Authors:
- 18 October 2011
- journal article
- research article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 25 (4) , 403-414
Abstract
UHMWPE composite materials are increasingly used in armors design due to their high strength-to-weight ratios and energy absorption capacities. In this study the effect of production parameters upon the terminal ballistic properties of UHMWPE composite were examined under different conditionings. The composite armor plate laminates were produced by hot pressing with three different pressing times from 10–30 minutes and the laminates conditioned at +115, +125, and +135°C. The molding temperature of SK66 fiber composite has the main direct effect on the ballistic absorption energy, so the relation of molding temperature with the adhesive bonding force between layers, the thickness of the laminates, pressure and time is investigated during the optimum of the molding parameters. The results show that when the molding temperature is about 125°C the ballistic absorption energy is up to the highest value. For the study of the principles of the ballistic absorption energy, the deformation and fracture area of the SK66 fiber composite laminates after ballistic impact are analyzed with the Taguchi method and the results are discussed in detail. Phenomena and mechanism of failure of the composite under ballistic impact were explained. The study results would be valuable for the optimum design.Keywords
This publication has 8 references indexed in Scilit:
- High velocity impact of thick compositesInternational Journal of Impact Engineering, 2003
- Post failure analysis of 0°/90° ultra high molecular weight polyethylene composite after ballistic testingJournal of Microscopy, 1999
- Tailoring the interface in polyethylene fiber/matrix composites: surface-entangled interfacial layerComposites Part A: Applied Science and Manufacturing, 1999
- Novel composites by hot compaction of fibersPolymer Engineering & Science, 1997
- A novel composite based on ultra-high-molecular-weight polyethyleneComposites Science and Technology, 1997
- Formulation, identification and use of interface models in the numerical analysis of composite delaminationInternational Journal of Solids and Structures, 1993
- Manufacturing and mechanical characterization of unidirectional polyethylene-fibre/polyethylene-matrix compositesComposites Science and Technology, 1992
- The concept of one polymer composites modelled with high density polyethyleneJournal of Materials Science, 1975