Natural Convection Immersion Cooling With Enhanced Optical Performance of Light-Emitting Diode Systems
- 15 October 2015
- journal article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 137 (4) , 041006
Abstract
Electronics driven at high currents may experience local hot spots, which may cause thermal degradation or even catastrophic failures. This common problem occurs at light-emitting diode (LED) chips and it is not easily observed by end-users. Driving over 700 mA over a 1 mm2 chip is expected to generate local temperature gradients. In addition, bonding failures at manufacturing or during operation (cracks, delamination, etc.) may also lead to local hot spots. Therefore, possible hot spots over an LED chip have turned attention to direct cooling with dielectric liquids comprises the current study. Computational and experimental studies have been performed to understand the impact of conduction and alternatively convection with various dielectric fluids to abate local hot spots in a multichip LED light engine. To capture the local temperature distributions over the LED light engine with a dome in the domain especially over the LED chip; first, computational models have been built with a commercial computational fluid dynamics (CFD) software. Later, attention has been turned into experimental validation by using a multichip high brightness LED (HB LED) light engine. An optothermal evaluation has been made at single and multiphase heat transfer modes with dielectric fluids (LS5252, HFE7000, and silicone oil, etc.) to compare with a series of CFD models and experimental studies. While multiphase liquid-cooled LED system has a better cooling performance but lower optical extraction, single-phase liquid-cooled LED system has shown a reasonable thermal performance with a 15% enhancement at light extraction.Keywords
This publication has 8 references indexed in Scilit:
- Self-Propelled Sliding Bubble Motion Induced by Surface Microstructure in Pool Boiling of a Dielectric Fluid Under MicrogravityJournal of Electronic Packaging, 2015
- On-Chip Power Generation Using Ultrathin Thermoelectric GeneratorsJournal of Electronic Packaging, 2014
- Modeling of Two-Phase Evaporative Heat Transfer in Three-Dimensional Multicavity High Performance Microprocessor Chip StacksJournal of Electronic Packaging, 2014
- Two-Phase Liquid Cooling for Thermal Management of IGBT Power Electronic ModuleJournal of Electronic Packaging, 2013
- Thermal management methods for compact high power LED arrays2007
- Enhancement of pool boiling critical heat flux in dielectric liquids by microporous coatingsInternational Journal of Heat and Mass Transfer, 2007
- Design of Air and Liquid Cooling Systems for Electronic Components Using Concurrent Simulation and ExperimentJournal of Electronic Packaging, 2006
- Advances in liquid coolant technologies for electronics cooling2005