Finite Element Analysis of Stress in Bone and Abutment-Implant Interface under Static and Cyclic Loadings
Authors:
- Saeed NokarSNSaeed Nokar
- Hamid JalaliHJHamid Jalali
- Farideh NozariFNFarideh Nozari
- Mahnaz ArshadMAMahnaz Arshad
Open Access
- 3 October 2020
- journal article
- research article
- Published by Knowledge E DMCC in Frontiers in Dentistry
- Vol. 17 (21) , 1-8
Abstract
Objectives: The success of implant treatment depends on many factors affecting the bone-implant, implant-abutment, and abutment-prosthesis interfaces. Stress distribution in bone plays a major role in success/failure of dental implants. This study aimed to assess the pattern of stress distribution in bone and abutment-implant interface under static and cyclic loadings using finite element analysis (FEA). Materials and Methods: In this study, ITI implants (4.1×12 mm) placed at the second premolar site with Synocta abutments and metal-ceramic crowns were simulated using SolidWorks 2007 and ABAQUS software. The bone-implant contact was assumed to be 100%. The abutments were tightened with 35 Ncm preload torque according to the manufacturer’s instructions. Static and cyclic loads were applied in axial (116 Ncm), lingual (18 Ncm), and mesiodistal (24 Ncm) directions. The maximum von Mises stress and strain values were recorded. Results: The maximum stress concentration was at the abutment neck during both static and cyclic loadings. Also, maximum stress concentration was observed in the cortical bone. The loading stress was higher in cyclic than static loading. Conclusion: Within the limitations of this study, it can be concluded that the level of stress in single-unit implant restorations is within the tolerable range by bone.Keywords
This publication has 19 references indexed in Scilit:
- Hybrid micro/nanostructural surface offering improved stress distribution and enhanced osseointegration properties of the biomedical titanium implantJournal of the Mechanical Behavior of Biomedical Materials, 2018
- A New Model to Study Fatigue in Dental Implants Based on Probabilistic Finite Elements and Cumulative Damage ModelApplied Bionics and Biomechanics, 2017
- A finite element study on stress distribution of two different attachment designs under implant supported overdentureThe Saudi Dental Journal, 2015
- Numerical study of effect of elastomeric stress absorbers on stress reduction in bone-dental implant interfaceJournal of Applied Oral Science, 2015
- Importance of Crown Height Ratios in Dental Implants on the Fracture Strength of Different Connection Designs: An In Vitro StudyClinical Implant Dentistry and Related Research, 2013
- A Photoelastic Stress Analysis of Screw‐ and Cement‐Retained Implant Prostheses with Marginal GapsClinical Implant Dentistry and Related Research, 2013
- Biomechanical effect of a zirconia dental implant-crown system: a three-dimensional finite element analysis.2012
- Finite element study on the effect of abutment length and material on implant bone interface against dynamic loadingThe Journal of Advanced Prosthodontics, 2011
- Stress distribution of an internal connection implant prostheses set: a 3D finite element analysis.2009
- Load fatigue performance of four implant-abutment interface designs: effect of torque level and implant system.2008