Measuring the Statistical Characteristics of a Microwave Fiber Optic Link in 0.5-12.5 GHz Range
- 19 October 2023
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 418-421
Abstract
A techniques to measurement noise figure of microwave fiber optic transmission line is given. Two method of noise figure measurement - the Y-factor method and the direct noise figure measurement method - are discussed and compared. The structure of lab setup of microwave fiber optic line and characteristics of its component, and characteristics of used measurement equipment are given. We measure output noise power spectral density, power gain and noise figure. Lab setup line has noise figure 28.5… 32.5 dB in studied frequency range.Keywords
Funding Information
- RFBR
This publication has 13 references indexed in Scilit:
- Radar range in multi-target modeJournal of Physics: Conference Series, 2021
- Signal detection algorithms for interferometric sensors with harmonic phase modulation: evaluation of additive noise effectsApplied Optics, 2021
- Performance Analysis for Massive MIMO Systems Based on Quadriga Channel Model2020
- Analysis of Joint Application of Optimal FTN Signal and 5G Error-Correction Code Schemes2020
- Main Characteristics Study of Analog Fiber-Optic Links with Direct and External Modulation in Transmitter Modules2018
- Model of Photonic Beamformer for Microwave Phased Array Antenna2017
- FUNDAMENTALS OF MICROWAVE PHOTONICS2015
- Cold-source measurements for noise figure calculation in spectrum analyzers2006
- Analog Optical Links2004
- Effects of dut mismatch on the noise figure characterization: a comparative analysis of two y-factor techniquesIEEE Transactions on Instrumentation and Measurement, 2002