Effects of divertor geometry and chemical sputtering on impurity behaviour and plasma performance in JET
- 1 March 2000
- journal article
- Published by IOP Publishing in Nuclear Fusion
- Vol. 40 (3) , 379-396
Abstract
The effects of increased geometrical closure on the behaviour of the recycling and intrinsic impurities are investigated in JET Mark I, Mark IIA and Mark IIGB pumped divertors. Increasing the divertor closure leads to a significant improvement in exhaust for both deuterium and recycling impurities. However, the impurity enrichment in the exhaust gases remains unchanged due to a simultaneous increase in deuterium and impurity compression in the divertor. A comparison is made for helium, neon and argon under different plasma conditions. In addition, the operation of the Mark II and Mark IIGB divertors has shown that Zeff is reduced with the improved divertor closure in the L mode discharges, although no obvious changes in the Zeff values have been observed in the ELMy H modes. The divertor target surface temperature has a strong influence on intrinsic carbon production. The carbon source in the Mark II and Mark IIGB divertors is significantly higher than that in the Mark I divertor, which is attributed to enhanced chemical sputtering at the increased divertor tile temperature of the Mark II and Mark IIGB divertors (related to the divertor cooling system), as opposed to the increased closure. The consequences of this elevated yield for plasmas under different operation conditions are discussed, and further evidence, obtained from a specific wall/divertor temperature reduction experiment, is presented. The effect of the divertor screening on the chemically produced impurities is investigated using the EDGE2D/NIMBUS/DIVIMP codes for the different recycling regimes and comparisons are made with experimental observations from the Mark I, Mark IIA and Mark IIAP divertors taking into account the change in chemical sputtering yield due to the different tile temperatures of these divertors.Keywords
This publication has 37 references indexed in Scilit:
- Chemical erosion of carbon based materials in fusion devicesJournal of Nuclear Materials, 1999
- In-vessel tritium retention and removal in ITERJournal of Nuclear Materials, 1999
- The Behaviour of the Apparent Chemical Sputtering Yield in the JET TokamakPhysica Scripta, 1999
- Evidence for hydrogen flux dependence of the apparent chemical erosion yield of graphite under high flux conditionsNuclear Fusion, 1998
- Isotopic effects in hydrocarbon formation due to low-energy H+/D+ impact on graphiteJournal of Nuclear Materials, 1998
- Analytic description of the chemical erosion of graphite by hydrogen ionsNuclear Fusion, 1997
- Chemical erosion measurements from various carbon based limiters and coatings in TEXTOR-94Journal of Nuclear Materials, 1997
- Analytic description of the chemical erosion of graphite by hydrogen ionsNuclear Fusion, 1996
- Status of ITERPlasma Physics and Controlled Fusion, 1995
- Burn condition, helium particle confinement and exhaust efficiencyNuclear Fusion, 1990