Load sharing ability of the liner in type III composite pressure vessels under internal pressure
- 18 November 2014
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 33 (24) , 2274-2286
Abstract
In this work, the load sharing ability of metallic liners in type III composite overwrapped pressure vessel was investigated by means of accurate numerical models based on finite element method in order to realistically represent the hybrid metal-composite structure. The varying thickness of the composite layers throughout the dome, as well as their angles, were accounted for in the model. The study focused on the influence of material properties and liner-to-composite thickness ratio on the stress and strain distribution between liner and composite at the cylindrical, dome, and polar boss regions. Two novel concepts for the evaluation of the structural response of a composite overwrapped pressure vessel were introduced, namely: (i) the liner stress and strain fractions, and (ii) the correlation with liner-to-composite thickness ratio. The results show complex overall behavior close to the onset of plasticity of the liner, which is critically investigated. A decrease in liner stress fraction was found for higher internal pressure loads since the stress field is increasingly dominated by the composite overwrap. Also, the von Mises equivalent stress along the longitudinal profile of the structure showed a peak at the dome of the liner, whereas for the composite, the peak was at the shoulder region. This was justified considering that, at low pressure, the liner operates elastically in compression-tension mode and the composite in tension-tension mode.Keywords
This publication has 12 references indexed in Scilit:
- Multi-sequence dome lay-up simulations for hydrogen hyper-bar composite pressure vesselsComposites Part A: Applied Science and Manufacturing, 2013
- Optimal design of a composite laminate hydrogen storage vesselInternational Journal of Energy Research, 2012
- Numerical tool to model collapse of polymeric liners in pipelinesEngineering Failure Analysis, 2012
- Evaluation of modeling techniques for a type III hydrogen pressure vessel (70 MPa) made of an aluminum liner and a thick carbon/epoxy composite for fuel cell vehiclesInternational Journal of Hydrogen Energy, 2012
- A new method for predicting dome thickness of composite pressure vesselsJournal of Reinforced Plastics and Composites, 2010
- Design, Fabrication, and Testing of Epoxy/ Glass-reinforced Pressure Vessel for High-pressure Gas StorageJournal of Reinforced Plastics and Composites, 2010
- Analysis of filament wound composite structures considering the change of winding angles through the thickness directionComposite Structures, 2002
- Self-Strengthening Research of Fiber Reinforced Pressure Vessel with Metallic LinersJournal of Reinforced Plastics and Composites, 2001
- Continuous Curing and Induced Thermal Stresses of a Thick Filament Wound Composite CylinderJournal of Reinforced Plastics and Composites, 2001
- Finite element analysis of composite pressure vessels with a load sharing metallic linerComposite Structures, 2000