A Microwatt Dual-Mode Electrochemical Sensing Current Readout With Current-Reducer Ramp Waveform Generation
- 21 August 2019
- journal article
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Biomedical Circuits and Systems
- Vol. 13 (6) , 1163-1174
Abstract
An electrochemical sensing chip with an integrated current-reducer pattern generator and a current-mirror based low-noise chopper-stabilization potentiostat circuit is presented. The pattern generator, utilizing the current reducer technique and pseudo resistors, creates a sub-Hz ramp signal for the cyclic voltammetric (CV) measurement without large-size passive components. The proposed design adopts the chopper-stabilization and low-noise biasing technique for the potentiostat and a counter-based time-to-digital converter to reduce the amplitude noise effects and to convert the sensing current signal to digital codes for further data processing. The design is fabricated using a 0.18-μm CMOS process and achieves a 41pA current resolution in the current range of $\pm$ 5μA while maintaining the R $^{2}$ linearity of 0.998. The system consumes 16μW from a 1.2V supply when a 5μA sensing current is detected. The power efficiency of the readout interface is 0.31, and the sensing current dynamic range is 108dB. The design is fully integrated into a single chip and is successfully tested in the dual-mode (CA/CV) measurements with commercial gold electrodes in a potassium ferricyanide solution in sub-millimolar concentrations.
Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (105-2628-E-009-007-MY3, 107-2221-E-009-127-MY3, 108-2636-E-009-008)
- Young Scholar Fellowship Program
- Taiwan Semiconductor Research Institute, Taiwan
This publication has 38 references indexed in Scilit:
- A Highly Digital VCO-Based ADC Architecture for Current Sensing ApplicationsIEEE Journal of Solid-State Circuits, 2015
- Adhesive RFID Sensor Patch for Monitoring of Sweat ElectrolytesIEEE Transactions on Biomedical Engineering, 2014
- An Integrated Control and Readout Circuit for Implantable Multi-Target Electrochemical BiosensingIEEE Transactions on Biomedical Circuits and Systems, 2014
- CMOS Neurotransmitter Microarray: 96-Channel Integrated Potentiostat With On-Die MicrosensorsIEEE Transactions on Biomedical Circuits and Systems, 2012
- A 3-$\mu\hbox{W}$ CMOS Glucose Sensor for Wireless Contact-Lens Tear Glucose MonitoringIEEE Journal of Solid-State Circuits, 2011
- Linear transconductor with rail-to-rail input swing for very large time constant applicationsElectronics Letters, 2006
- Triangular/Square-Wave Generator With Independently Controllable Frequency and AmplitudeIEEE Transactions on Instrumentation and Measurement, 2005
- Understanding MOSFET mismatch for analog designIEEE Journal of Solid-State Circuits, 2003
- A CMOS potentiostat for amperometric chemical sensorsIEEE Journal of Solid-State Circuits, 1987
- Cyclic voltammetryJournal of Chemical Education, 1983