High efficiency homojunction InP solar cells
Authors:
- 1 November 1985
- journal article
- Published by AIP Publishing in Applied Physics Letters
- Vol. 47 (9) , 975-977
Abstract
Homojunction InP solar cells with a high conversion efficiency of 18.0% have been fabricated using thermal diffusion of sulphur into p-type InP. An open-circuit voltage Voc as high as 0.837 V which resulted from a reduction in leakage current was attained by employing mesa etching as a method for sectioning cells on a diffused wafer. Fill factor was also increased to 82.9% owing to both a small diode ideality factor (≲1.3) and a low cell series resistance (≲0.5 Ω cm2). As a result of the improvement in these factors, a conversion efficiency as high as 18.0% (an active-area conversion efficiency of 20.1%) under AM1.5 illumination was obtained. A phenomenon whereby shunt resistance in a mesa-etched cell is reduced by illumination is discussed. This is due to the additional current flowing from the peripheral p-InP region bared by the mesa etching.Keywords
This publication has 6 references indexed in Scilit:
- High efficiency indium tin oxide/indium phosphide solar cellsApplied Physics Letters, 1985
- Radiation damage in InP single crystals and solar cellsJournal of Applied Physics, 1984
- High conversion efficiency and high radiation resistance InP homojunction solar cellsApplied Physics Letters, 1984
- Electron Irradiation Damage in Radiation-Resistant InP Solar CellsJapanese Journal of Applied Physics, 1984
- Inversion layers on InPJournal of Vacuum Science and Technology, 1979
- A 15% efficient silicon MIS solar cellApplied Physics Letters, 1978